How ta open the loading door Opening the loading door — before the machine is connected. 1 Turn rotary control for emergency drain {A) a quarter turn anti-clockwise to the stop siphon. . Using a coin turn disc (8) anti-clockwise untie the loading door springs open. . Turn rotary control for emergency drain (A} in clockwise direction. 7 Penning the loading door — tater the machine has been connected o the power supply. Press button.
sur Lava mat 3. 1A Programmer defector and programmer progression indicator g A/B Temperature selector 3.1/C On/Off button with indicator lint g #/D Door release button g 1/E Button for gays-care fabrics and short programmed g. 1/F Bunion for dedicates g. 176G Burton for wool Fig. 1/H Button for small roads Fig. 141 Fig. 1K AROMATIC bunion Fig. 1/, Button for lower spin speed Flg. 1/M Detergent dispenser (with double sided programmer chart’, removable) Fig. 1/M _ Quire door with inner road behind.
Sorting the laundry Ranting the laundry Check the manufacturer's instructions or the care label inside each garment {see the international Textile Care La belling Code in the programmer chart). The laundry should be sorted into: Cottons and linens {whites and coloreds) Easy-care fabrics Delicate synthetics Swollen Practical Hints W Do not mix whites and coloreds as the whites will become Grey. | New items tend 1o lose some of their color when washed for the first time.
Load sizes Yau will find details as fo how much laundry you can wash in your making in the programmer chart but you may find the following general information useful; B When washing cottons and fines fill the drum with dry laundry heaving & space of 8 hand's breadth between laundry and the top of the drum, W A W-liter (2, gallon) bucket will take approximately 2.5 kg of tightly packed dry laundry {cottons and fineness. | Distribute the laundry i the drum as loosely 48 possible.
Explanation of controls With the exception of woo alt fabrics can be washed with or without a per-wash. “To select & wash programming set the programmer selector {figure 1/A} o the required programmer number, the temperature selector {figure 178} to the required temperature and press any selector bitten {s) required (figure 1/E to L), Programmer selector The programmer selector has 7 settings for the rain and the additional programmed.
Explanation of controls By defecting E in conjunction with a programmer you wilt save up o 40% energy as the machine wiki carry out a somewhat longer wash at 40 °C instead instead of85°C. &-d@ Press. bole buttons for. a very. economical wash. of small loads of lightly sliced cations and linens and easy-care fabrics. Buttons @ Button for AROMATIC Spinning {Huger 17K) 1. Press this button f you want 2 AROMATIC spin instead of the normal spin at the end of 2 cottonseed programmer.
Programmer selection Programmer Cycle Programmer Temperature Buttons Selector Selector 4 @ Rinsing — spinning Ringing with rinse hold") 5 O Spinning far sundry washed and rinsed by hand Pump out gentle AROMATIC spin — for laundry washed by hand 6 e o Pr-wash {soaking)i— fills 1o high water level = laundry s left in the wash solution. Proceed as tor fine hold*) 7 D Pump out, e.g.
How to look after your Lava mat Protecting the machine against frost Any damage due to frost is not covered by warranty, i the machine is situated in a room which might be affected by frats, any water st be removed from the drain pump (see “Emergency drain® below) as well as from the rawer inlet hoses {disconnect the infer hoses from the water saps and drain) Cara and maintenance The detergent dispenser requires cleaning from time 1o time. Fo do tis remove the drawer completely by ling it aut.
It you think your machine is not working properly However, movement may also result from: W Blocked drain pus. *® Kinked or twisted drain hose. W Transit bars have not been removed. M The making is not installed properly (see installation instructions supplied). ‘The machine is overdressing | Have you used 100 much washing powder? Usa less powder for the next wash or omit the: per-wash.