Contents Your Malayalam I m&gqm Fully automatic :*gqe shd terribleness. With a little crag and intention, It will give you many years of faithful service.
Explanation of controls Wash Besides the off position »8« the prophet wash programmer selector should programmer gamma defector has 5 settings for only be turned clockwise and when the selector he basic programmed and the machine is switched off. Pauli aut the and nonvocal additional programmables. These are: wash programmer selector to start the control 1 Wash programmer with pro-wash programmer.
Explanation of controls 3 5 Dot release button Te open the door electrically: & set {he wash programmer selector {1} to tha «B« position, pule out and press the door release button. ® after a programmer with rinse water stop, push In tha wash programmer detector {1), turn 1o programmer 5, pull out the selector and wall uni ll i has returned to the =B« position. # after a programmer with spinning Walt until the automatic safety lock has been released (approx. 1 minute after the and of the spin cycle).
Hints on stain removal " Impotent If possible remove stains 1 Do not use stale remover in the immediately with lukewarm water and washing machine: soap. Sating which have been lel! are £1 Do not inhale solvents. more difficult to remove. Use a clean, They can damage your health. absorbent cloth. Do not rub but dab 1 Take cars when handling the stain. Bleaching agents and many inflammable stain removers.
Washing powder, conditioner and starch 13 Be lore sectioning & programmer, pour washing powder and fabric conditioner into the relevant compartments of tha dispenser. To do this pull open the dispenser drawer. You will find 4 compartments as illustrated above.
‘Washing powder, conditioner and starch Practical Hints [J How much washing powder you 1 If 8 measuring beaker is supplied usa depends on the water hardness with the washing powder do not fii {soft, medium, hard, very hard), the above the Indicator novel. ¥ too much quantity of foundry and the degrees of powder |5 used, excessive foaming soling. Your locate Water Board wii may scour. This interferes with the advise you on the hardness of the movement of the laundry in the drum water in your area.
Check list — before selecting a programmer 15 it the machine % not Pius In the machine and switch on at the prows socket. hose, use the hose holder provided. (For further details sea permanently 2. Make sure that the drain hose g gaps 26). plumbing not kinked and is securely hooked 3. Connect the water infer hose ta over the sink edge. If the sink tha tap. edge is too wide to hold the Before you 1. Open the water tap. compartments 1 loanword 2, issuance trifecta 2.
Tumble drying 18 Spinal Drying times depend on the amount important: bafflers of water extracted during spinning. Be Make sure that the laundry Is tumble drying sure to select the correct spin for the distributed loosely in the drum before different fabrics. selecting tumble drying to avoid heat damage to the foundry. Sorting the Different fabrics require different Do not rumble dry: laundry drying times. Textile articles which have been treason the foundry into: ted with inflammable liquids.
Tumble drying Cottons Before tum bis drying: Horne Chlorination spin 1100 rpm. Using the # Hook the drain hose over the ® 1f the laundry I3 no! removed at dryer sink adj, connect the Inlet this stags the cooling down hose 10 the water tap and turn process will continue for a on the tap. further 30 minutes. The Laundry © Distribute laundry loosely In the can be removed at any time drum and close tha door. during this cycle.
H you think your machine Is not working properly Non functioning of your Washer/ Dryer is mostly due to minor causes which you can rectify yourself. Before you call oul a service engender please check through the fail Minding ~. chart below. The Programs does not start 0 Is the making plugged in? L1 Are the Tues In working order? [} Have you closed the powder drawer property? [1 Check that the machine door fs tulle closed.
H you think your machine Is not 23 working properly The machine vibrates or moves 1 theta Is too little laundry In the drum {e.g. just one dressing gown, bath mat etc} this may chad to vibration, Therefore, wash more lams. Ho waver, movement nay also result from: Blocked drain filter. Transit bars have not been removed, The machine is not Installed proper (see page 20} 0 coo Kinked or twisted drain hose. Hus spots In the drum The drum of your machine Is made of stainless steer and cannot rust.
Care and maintenance Drain fighter The drain fitter collects Ruff, ® Remove the plug from the buttes, pins etc. which may emergency drain hose and drain fave been put into the drum with the residue water Into a shallow tha sundry. You should, there dish (see Illustration on the daft fore, clean the drain fleeter above). regularity. & Close emergency drain hose. e Pull the te ® Unscrew the filter ant-clockwise. remove.
Care and maintenance Warier Initiate filter The Hitler traps any particles which may be present In the water supply system. if the washing powder is not ted into the machine one of the reasons for this maybe a blocked filter, To clean the fleeter: ® Close the water tap ® Carefully unscrew the water Inlet hose from the machine. # Ba move the filter as illustrated on the left above. ® Clean under running water. Push stubborn particles through! the metal mesh using a pin.
How to remove the transit bars ., EGOS ALK, To remove the transit bars process as follows: Remove both hex. nuts (a) {illustration 1) on the roar of the machine using the spanner supplied. You will find the screwdriver in the detergent dispenser. Remove 3 craws {b) on ether SIDS with the spanner (illustration 2. Pull bar {d) {illustration 1) and remove. Pull out distance tubas (g} (illustration ). H necessary pull wooden batten to get a better grip o the distance tubas {e), .
Installation and connection 27 Water supply Your washing machine is fitted wih & high quality high pressure hose {1.2 m ¥s’* bore} with a ¥s ** BSP. screw connector for connection to a water valve with male thread, The necessary washers are enclosed. Please do not use any other washers #% these may be of unsatisfactory quality. Hand tightening of the connector nut is sufficient be very careful when using tools. Saa illustration above how lo connect the Inlet hose.
installation and connection Waster To drain the making of all wash and Check that the drain hose is not Discharge fines water it Is fitted with a pump kinked or twisted. It a permanent which Is controlled by the pro connection 10 a siphon [s required, gram me. [t dell vars wale to a height you can shorten the drain hose through the drain hiss. necessary. {in this case the hose To fit the drain hose push It Approx. must be ventilated.
Installation and connection 29 Installation Dimensions with worktop Height 85 cm Width 60 cm Depth 80 cm without worktop Height 82 cm Width 60 om Depth B0 cm The LAVA MAT stands on four adjustable fest, so that you have airways the possibility 1o compensate uneven floor conditions or 1o adjust the machine to the sight of the adjacent furniture units. {max. 20 mm). Yo vary tha height of iha foot we have enclosed a spanner.
Decor panel sizes I Standard plinth height 100 mm, variable between 100 and 180 mm {see illustration below}. To adjust the plinth height and fit decor panels proceed as follows: — The lower panel Is sacred 1o the making by one catch an either side at the top and one magnet on either side at the base of the machine. Important: Release Tower panel from the catches at the top, then pull forward to release from magnets.
How to build in your Lava mat into a fitted kitchen 31 The appliance can be bullion under 3 continuous work surface. To remove the machine worktop proceed as follows: — Remove both hex-headed screws under the worktop at the rear {Frustration 1). w Phil the worktop approx. 3 cm towards the rear of tha machine and i off. — Ramos plastic spacer by pushing towards the rear of the machine {illustration 2). ~A hover panel (EY No,. 845 424 013) has to be fitted 1o the top of the machine for safety.
Transfuse? No. from the rating plats if you require 10 have your LAVA MAT serviced you will assist our service department by quoting the E-No, which we have listed above and the F-No. which you wolf find on the raking piste behind the lows pane above the filter Hap. Record the F-No. in the space provided above for future reference. 541.600.