Please read and follow the instructions in this bookie Separate instructions on installation and connection are supplied with the machine. Important To avoid damage during transit we have fitted transit bars 1o the machine. Please remove these before installing and connecting the machine. You will find details how to do this an the red sticker on the washing machine and in the installation instructions.
Your LAVA MAT Figure 1/A Programmer selector Figure 1/8 Temperature selector Figure 1/C Button for easy-care fabrics and wool Figure 1/0 Button for small loads Figure 1/E Door control light (yellow) Figure 1/F Detergent dispenser with double sided programmer chart® removable, rating plate under dispenser Figure 1/G Door with handle and latch {child safety lock) Figure 1/H Drain pump with pool-out emergency drain bite to the ett Check list what to do before and after every programmer # the machine is not per
Sorting the laundry Sorting the laundry Check the manufacturer s instructions of the care label inside each garment (see the International Textile Care La belling Code in the programmer chart). The laundry should be sorted into Cottons and tines (whites and coloreds) Easy-care fabrics Delicate synthetics Woolens, Practical Hints ® Do not mix whites and coloreds as the whites wil become Grey. B New items tend to lose some of their color when washed for the first time.
Load Sizes You will find details as to how much laundry you can wash in your making in the programmer chart but you may find the following general information useful: ® When washing cottons and linens il the drum with dry laundry leaving a space of a hand's breadth between laundry and the top of the drum. ™ A 10-tire (2'/2 gallon) bucket will take approximately 25 kg of tightly packed dry laundry (cottons and linens).
Explanation of controls With the exception of wool ali fabrics can be washed with ar without & per-wash To select @ wash programmer set the programmer selector (figure 1/A) to the required programmer number, the temperature selector {figure 1/B} to the required temperature and press any detector button{s) required {figure 14CID). Programmer selector The programmer selector has 11 settings for the main and the additional programmed.
How to switch the machine on and off How 1o sitar the machine 1. Turn the programmer selector {only in the pushed In state) clockwise to the required programmer, select the required temperature and press any buttons as required {see programmer chart), 2. PULL GUT the programmer selector (10 switch on the machine). A white band will be visible to indicate the machine is switched on. The door control light comes. on as soon as the door is locked.
programmer Selection programmer Temperature Bunions! Programmer Cycle Malt Los Note fester _ Sector or2 185 Pr-wash — main wash @ with per-wash 4 rinses spinning 2,3, 4,9 without per-wash 3 o Pr-wash — shorter main @ Load size for wash — 4 rinses W Lightly to normally spinning soiled laundry 5 kg ord ey Pr-wash — main wash ~ i) W Heavily soiled laundry 4 rinses spinning 5kg or3 o Pr-wash ~ main wash ~ i) 4 rinses-spinning a wy Shortened main wash ~ & 4 finches spinning or2 oL Pr-wash — main wash — i) ) Rins
Programmer Cycle Small Notes toad Rinsing spinning & Rinsing with @ *) Rinse hold rinse hominoid} The laundry is left in the last rinse water. Spinning for laundry washed and rinsed by hand Pr-wash {soaking) files (o high water level — laundry i left in the wash solution. Proceed as for rinse hold*) Pump out short spin * (After a rinse bold programmer or for laundry washed and rinsed by hand} Pump out, €. g. following a programmer with tinge hold") Before opening the door, release button L.
Protecting the machine against frost Any damage due to frost is not covered by warranty. If the machine is situated in a room which might be affected by frost, any water must be removed from the drain pump (see emergency drain this page} as well as from the wale infer gases (disconnect the infer hoses from the water tap and drain). Care and maintenance The detergent dispenser requires cleaning from time 10 time 1o time. To do this remove the drawer completely by pulling it out. Clean the dispenser.
if you think your machine is not working properly The door cannot be opened immediately the programmer {s interrupted M The machine has a satiety lock which will only be released after 1 1o 2 minutes. Water is leaking from underneath the machine B Check the water inlet hose connections to the tap and 1o the machine. Check the drain hose connection to the machine. W Check the water inlet and outlet hoses for leaks. W Check that the drain pump cover is closed properly {see “Cleaning the drat pump').
Service Should you be unable to locate the cause of the problem in spite of the check fist "1t You think your machine is nat working property, then please contact your AEG Service Department. I you require to have your machine serviced you will assist the Service Department by quoting the F and £ numbers which you will find on the rating plate under the detergent dispenser.
244 221 440 ~ ~ Sui est 5 Sty Aol oty AEG Domestic Appliances Ltd Customer Care Department 5877 High Street Slough Berkshire 8L1 1DZ Telephone: 08705 350350