Please read and follow the instructions in this booklet Separate instructions on installation and connection are supplied with the machine. Important To avoid damage during transit we have fetid transit bars to the machine. Please remove these Before installing and connecting the machine.
Opening the loading door — before the machine is connected. Open the flapping base, bottom left and pull down cord to release the door dock. Close the flap afterwards. k4 Opening the loading door tater the machine has been connected to the power supply. A: Switch on the appliance. B: Cross button The door can only bé opened when the drum has stopped and the water level is below that of the Loading door.
AMENDMENT TO LAVA MAT 570 Dear Customer, We have improved accessibility for the emergency drain hose described in the instructions for use. The hose in now arranged beside the drain pump flap. For emergency drainage of the machine, rotate plug with a coin one quarter revolution to the deft {counterclockwise. Withdraw hose as illustrated and remove plug. Ali ow residual water to drain into a suitable vessel (place lath below}. Finally, refasten nose with plug and insert hose.
Your Lava mat Fig. 174 Programmer selector and programmer progression indicator Fig. 1/8 Temperature selector Fig. 1/C On/Off button with indicator fight Fig. /D Door release button Fig. 1/E Button for easy-care fabrics and short programmers. Fig. 1/¢ Button for delicate Fig. 1/G Bunion for wool Fig. 1/H Button for slam loads Fig. 11 Fig. 1/K AROMATIC hut tor Fig. 1/L Button far energy saving programmers Button for lower spin speed Fig.
Sorting the laundry Sorting the laundry Hack the manufacturer's instructions of the care fable inside each garment (see the international Textile Care La belling Code ir the programmer chart. The laundry should be sorted into: Cottons and linens (whites and coloreds) Easy-care fabrics Delicate synthetics Woolens, Practical Hints W Do not mix whites and coloreds as the whites wil became Grey. W New items tend to lose some of their color when washed for the dust time.
Load sizes You wilt find details as to how much laundry you can wash io your making in the programmer chart but you may fin the following general information useful: ® When washing cations and fines fill the drum with dry Laundry leaving a space of & hand's breadth between laundry and the top of the drum, W A 10-lice (2'/2 gallon) buck! will take approximately 2.5 kg of lightly packed dry laundry {cottons and linens). ® Distribute the laundry in the drum as loosely as. possible.
Explanation of controls With the exception of woo all fabrics can be washed with or without a per-wash. To select a wash programmer set the programmer selector (figure 1/A) 1o the required programmer number, the temperature selector {figure 1/8) tithe rewarmed temperature and press any selector button {s) requited {figure 1/E to L), Programmer selector The programmer selector has 7 settings for the main and the additional programmed.
Explanation of controls By detecting E in conjunction with a programmer a8 or 1% you will save energy haste machine wilt carry out a somewhat longer wash at 40’ Instead instead of 95°C. &+ Press both buttons for a very economical wash of sat loads ot lightly soiled cottons and linens and easy-care fabrics. Buttons Button: for AROMATIC Spinning {figure 1/K} 1. Press this bunion it you want a AROMATIC spin instead of the normal spin at the end of 4 cotton linen programmer.
Programmer selection Programmer Cycle Programmer Temperature Bunions Selector Selector 4 o Rinsing spinning 4 Rinsing with @ tinge hold") 5 O Spinning for laundry washed and rinsed by hand 5 Pump out— -l @ ® genre AROMATIC spin for laundry washed by hand Pr-wash (soaking) — fills 10 high water feel ~ laundry is heftiness the wash solution. Proceed as. for rinse hold*) 7 @ Pump out, ..
low to look after your Lava mat -protecting the machine against frost 1y damage due 10 frost is not covered by arrant. ¥ the machine is situated in a room vice might be attested by frost, any water must + removed trim the drain pump (see page 17).
If you think your machine is not working properly However, movement may also result from: ® Blocked drain pump M Kinked or twisted drain hose M Transit bars have not been removed M The machine is not installed properly (see installation instructions supplied). “The machine is overdressing 8 Have you used 100 much washing powder? Use less powder for the next wash or omit the pro-wash.
Service Should you be unable to locate the cause of the problem in spite of the check list ”H you think your making Is not working properiy™, then please contact your AEG Service Department. 1 you require to have your making serviced you will ageist the Service Department by quoting the £ and E numbers which you will find on the rating plate {see access flap 1o drain pump figure 1/N).