L 72470 FL L 72670 FL EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 CONTROL PANEL . . . . . . . . . . . . . . . . . . . . .
ENGLISH 3 1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.aeg.com • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • The operating water pressure (minimum and maximum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) • The ventilation openings in the base (if applicable) must not be obstructed by a carpet. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. 2.
ENGLISH Water connection • Make sure not to cause damage to the water hoses. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage. 2.2 Use WARNING! Risk of injury, electrical shock, fire, burns or damage to the appliance.
www.aeg.com 3. PRODUCT DESCRIPTION 1 2 3 Control panel 3 4 Door handle 5 Rating plate 6 Drain pump filter 7 Feet for the appliance level 4 5 3.1 Fixing plate kit (4055171146) Use this special accessory, when you install the appliance on a plinth. It prevents the movements of the appliance when it operates. Read carefully the instructions supplied with this accessory. You can buy it in all approved Service. 6 7 1 Worktop 2 Detergent dispenser 4.
ENGLISH 7 4.1 Display A B C A) The temperature area: – : Temperature indicator – : Cold water indicator. B) The spin area: – : the Spin speed indicator – : the No Spin indicator1) – : the Rinse Hold indicator. C) The display indicators: – : the washing phase – – : the spin phase – : the child safety lock – : the Door locked – : the delay start.
www.aeg.com Programme Temperature range Easy Iron1) ( Easy Iron ) 60°C - Cold Delicates ( Delicates ) 40°C - Cold Type of load and soil Maximum load, Maximum spin Synthetic fabric items. Normal soil and light soil. 3.5 kg, 1000 rpm Delicate fabrics as acrylics, viscose, polyester items. Normal soil and light soil. 3.5 kg, 1200 rpm Wool/SIlk ( Wool/Silk ) 40°C – Cold Machine washable wool, hand washable wool and delicate fabrics with «hand washing» care symbol.
ENGLISH 9 programme». They are the most efficient programmes in terms of combined energy and water consumptions for washing normally soiled cotton laundry. The water temperature of the washing phase may differ from the temperature declared for the selected programme.
www.aeg.com 6. CONSUMPTION VALUES At programme start the display shows the duration programme for the maximum load capacity. During the washing phase the programme duration is automatically calculated and can greatly be reduced if the laundry load is lower than the maximum load capacity (e.g. Cotton 60°C, maximum load capacity 7 kg, the programme duration exceeds 2 hours; real load 1 kg, the programme duration don’t reach 1 hour).
ENGLISH 11 7. OPTIONS 7.1 Temperature 7.4 Extra Rinse Set this option to change the default temperature. = cold water. Indicator The display shows the set temperature. With this option you can add some rinses to a washing programme. Use this option for persons allergic to detergents and in areas where the water is soft. The related indicator comes on. 7.2 Spin With this option you can decrease the default spin speed. The display shows the indicator of the set speed.
www.aeg.com 7.9 Acoustic signals The acoustic signals operate when: • You activate the appliance. • You deactivate the appliance. • You press the buttons. • The programme is completed. • The appliance has a malfunction. To deactivate/activate the acoustic sigand at the same time nals, press for 6 seconds. If you deactivate the acoustic signals, they continue operate when the appliance has a malfunction. 8. BEFORE FIRST USE 1. Put 2 litre of water in the detergent compartment for washing phase.
ENGLISH 13 Detergent compartment for prewash phase. Detergent compartment for washing phase. Compartment for liquid additives (fabric conditioner, starch). Flap for powder or liquid detergent. Liquid or powder detergent 1. 2. 1 A 2 3. 4. B • Position A for powder detergent (factory setting). • Position B for liquid detergent. When you use the liquid detergent: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid then the maximum level. – Do not set the prewash phase.
www.aeg.com • The display shows: – the default temperature – the spin speed – the indicators of the programme phases – the programme duration. 2. If necessary, change the temperature, the spin speed, the cycle duration, or add available options. When you activate an option, the indicator of the set option comes on. If you set something incorrect, the display shows the message Err. 9.5 Starting a programme without delay start Press : • The indicator stops to flash and stays on.
ENGLISH Open the appliance door when the delay start operates: 1. Press to pause the appliance. 2. Wait until the door lock indicator goes off. 3. Open the door. 4. Close the door and press again. The delay start continues to operate. Open the appliance door when the programme operates: 1. Press the button for some seconds to deactivate the appliance. 2. Wait for some minutes and then open carefully the appliance door. 3. Close the appliance door. 4. Set the programme again. 9.
www.aeg.com • Button up pillowcases, close zippers, hooks and poppers. Tie up belts. • Empty the pockets and unfold the items. • Turn inside out multilayered fabrics, wool and items with painted illustrations. • Remove hard stains. • Wash with a special detergent heavy soil stains. • Be careful with the curtains. Remove the hooks or put the curtains in a washing bag or pillowcase. • Do not wash in the appliance : – Laundry without hems or with cuts – Underwired bras.
ENGLISH 17 11.2 Descaling 11.3 Maintenance wash If the water hardness in your area is high or moderate, we recommend that you use a water softener for washing machines. Regularly examine the drum to prevent limescale and rust particles. To remove rust particles use only special products for washing machine. Do this separately from the laundry wash. With the low temperature programmes it is possible that some detergent stays in the drum. Make regularly a maintenance wash.
www.aeg.com 11.6 Cleaning the drain filter WARNING! Do not clean the drain filter if the water in the appliance is hot. 2. 1. 1 1 2 3. 4. 2 1 5. 6.
ENGLISH 7. 8. 1 2 9. 11.7 Cleaning the inlet hose and the valve filter 1. 2.
www.aeg.com 3. 4. 20° 11.8 Emergency drain 1. Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (9) of 'Cleaning the drain filter'. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate again the drain system: 1. Put 2 litres of water in the main wash compartment of the detergent dispenser. 2. Start the programme to drain the water. 2. 3. 4. 5. 6.
ENGLISH Problem 21 Possible solution The programme does Make sure that the mains plug is connected to the not start. mains socket. Make sure that the appliance door is closed. Make sure that there is not a damaged fuse in the fuse box. Make sure that the Start/Pause has been pressed. If the delay start is set, cancel the setting or wait for the end of countdown. Deactivate the Child Lock function if it is on. The appliance does not fill with water. Make sure that the water tap is open.
www.aeg.com Problem Possible solution There is water on the floor. Make sure that the couplings of the water hoses are tight and there is not water leakages. Make sure that the drain hose have no damages. Make sure you use the correct detergent and the correct quantity of it. You cannot open the appliance door. Make sure that the washing programme is finished. Set the drain or the spin programme if there is water in the drum. The appliance makes an unusual noise.
ENGLISH Electrical connection: Voltage Overall power Fuse Frequency 230 V 2200 W 10 A 50 Hz Level of protection against ingress of solid particles and moisture ensured by the protective cover, except where the low voltage equipment has no protection against moisture Water supply pressure 23 IPX4 Minimum 0,5 bar (0,05 MPa) Maximum 8 bar (0,8 MPa) Cold water Water supply 1) Maximum load Cotton Spin speed Maximum 7 kg 1400 rpm (L72470FL) 1600 rpm (L72670FL) 1) Connect the water inlet hose to a
132910050-A-282013 www.aeg.
