User manual

43
Installation
The inlet hose must not be lengthened. If it is too
short and you do not wish to move the tap, you
will have to purchase a new, longer hose specially
designed for this type of use.
Installation should comply with local water authority
and building regulations requirements. A minimum
water pressure of 0.05 MPa is required for safe
operation of the appliance.
If you cannot make the cold water connection direct from
the rising mains, you may be able to operate the appliance
from your cold water storage system. There should be a min-
imum distance of between the appliance’s inlet and the bot-
tom of the water storage tank.
Water-stop device
The inlet hose is provided with a water stop device,
which protects against damage caused by water leaks in the hose which
could develop due to natural ageing of the hose. This fault is shown by a red
sector in the window “
AA
”. Should this occur, turn the water tap off and refer
to your Service Centre to replace the hose.
Water drainage
This appliance is designed to be permanently plumbed
into your home's drainage system using one of the
following methods.
1. Into a drainage standpipe.
Firstly form a hook in the end of the drain hose using
the “U” piece” supplied.
Place the drain hose into your
standpipe, which should have an
internal diameter of approximately
38mm thus ensuring there is an air
break between the drain hose and
standpipe.
P1199
U piece
supplied
A
352
30 cm (12")
38 mm (1.5)
standpipe
diameter
132966711.qxd 05/03/2008 14.50 Pagina 43
Downloaded From WashingMachine-Manual.com Manuals