Please read and follow the instructions in this booklet Separate instructions on installation and connection are supplied with the machine Important To avoid damage during transit we have fitted transit bars o the making. Please remove these before installing and connecting the machine. Yo wilt find details how ta do this on the red sticker on the washing machine and in the installation instructions. Any residue of water in the making is due to our thorough tests before the machine leaves the factory.
Opening the loading door before the machine is connected. 1 Turn rotary control for emergency drain (A) quarter tum anti-clockwise ta the stop position. Using a Cain turn disc (B) anti-clockwise until the loading door springs open. Turn rotary control for emergency drain (A) in clockwise direction. T A Opening the loading door — after the machine has been connected ta the power supply. Press button.
Your LAVA MAT Fig. 1/ Wash programmer selector and programmer progression indicator Fig. 1/B Temperature selector Fig. 1/C On/Off button with indicator fight Fig. 1/D Door release button Fig. 1/E Button for easy-care fabrics and short programmed Fig. 1/F Button for delicate Fig. 1/G Button for wool Fig. 1/# Bunion for small roads Fig. 141 Fig. 17K Button for lower spin speed Fig. /L.
Sorting the laundry Sorting the laundry Check the manufacturer's instructions or the care abet inside each garment {see the international Textile Care La belling Code in the programmer: chart). The laundry should be soled into: Cottons and tines (whites and coloreds) Easy-care fabrics Delicate synthetics Woolens Practical hints W Do ot mix whites and coloreds as the whites will become Grey. W New items tend to foes some of their color when washed for e first time.
Washing powder, conditioner and starch M Ina autocratic washing making you need to use a low lather washing powder. We recommend Artie automatic which has been specially formulated for automatics M| To slot rinse or starch laundry be surf 1o use guided fabric conditioner {we recommend Leno) or starch.
Explanation of controls With the exception of wool alt fabrics can be washed with or without a per-wash. To select a wash programmer set the programmer selector (figure 1/A) to the required programmer umber, the temperature selector (figure 1/B} to the required temperature and dress any selector button {s} required (figure Veto. Programming selector ‘The programmer selector has 7 settings for the main and the additional programmed. The.
Explanation of controls By selecting € in conjunction with a programmer at 89 or \38} you will save energy as the machine will carry out & somewhat finger wash at 40° C instead instead of 95°C. &+ Press both buttons for & very economical wash of snail goads of lightly spited cottons and linens and easy-care fabrics. 1000 Button to reduce spin speed from 650 1000 r. p.m. to 650 r.p. m. {figure 1/K), Press this button if you wish 1o reduce the spiry speed trim 1000 Lo 850 v.p.m.
Programmer selection Programmer cycle ProgrammeTemperature- Buttons defector selector 4 — @ Rinsing spinning Rinsing with rinse hold™ 5 o Spinning ~ for laundry washed and rinsed by hand Pump out — genie AROMATIC spin — for laundry washed by hand & LW (D Pr-wash (soaking) fills to high water level — laundry is left in the wash solution. Proceed as tor rinse hold” 7 — o Pump out, 2. 9. following a programmer with tines hold™ * Rinse doth The laundry is left in fast rinse water.
How to look after your LAVA MAT Protecting the machine against frost Any damage due to frost is not covered by warranty. If the machine is situated in a room which might be affected by frost, any water must be removed from the drain pump {see “Emergency drain” below} as well as from the water inlet hoses {disconnect the inlet hoses from the water taps and drain). Care and maintenance The detergent dispenser requires cleaning farm time to time. To do this remove the drawer completely by pulling it out.
If you think your machine is not working properly However, movement may also result from: W Blocked drain pump M Kinked or twisted drain hose M Transit bars have not been removed M The machine is not installed properly {see installation instructions supplied). ‘he machine is overdressing W Have you used too much washing powder? Use less powder for the next wash or omit the per-wash.
Service Should you be unable to notate the cause of the problem in spite of the check list “if you think your making is not working properly”, then please contact your AEG Service Department. if you require to have your machine serviced you will assist the Service Department by quoting the F and £ numbers which you will find on the rating plate under the detergent dispenser.