Operation Manual

Setting Implementation
Emptying water res-
ervoir
- warning
off
2)
1. Turn the programme selector to any programme.
2. Press simultaneously the SPIN SPEED (T/MIN) and TIME (TIJD
PROGR.) buttons and hold down for approx. 5 seconds.
The current setting is on the display:
–
warning
icon and - warning message is off
–
warning
icon and - warning message is switched on
1) Water contains, a variable quantity of limestone and mineral salts of which quantities vary according to
geographical locations thus varying its conductivity values. Relevant variations of the conductivity of the
water compared to those prefixed by the factory could slightly influence the residual humidity of the
laundry at the end of the cycle. Your dryer allows you to regulate the sensitivity of the drying sensor based
on conductivity values of the water.
2) By default the warning LED is always on at the end of the drying cycle or during the cycle if the water
reservoir is full. When using an external drain for the condensed water warning can be offi
TECHNICAL SPECIFICATIONS
Height x width x depth 85 x 60 x 58 cm
Drum volume 108 l
Depth with loading door open 109 cm
Height can be adjusted by 1.5 cm
Weight when empty approx. 56 kg
Loading volume (depends on programme)
1)
max. 7 kg
Voltage 230 V
Necessary fuse 6 A
Total power 1050 W
Energy efficiency class
A
Energy consumption (7 kg of cotton, pre-
drained at 1000 rpm)
2)
1.9 kWh
Average annual energy consumption 126.2 kWh
Use Domestic
Permitted ambient temperature + 5°C to + 35°C
Consumption values
The consumption values have been established under standard conditions. They can deviate
when the appliance is operated in domestic circumstances.
Programme applianceaverage drying time in min.
Technical specifications
101