Operation Manual

1. Open loading door
2. Pull off adhesive strips from inside appli-
ance on top of drum.
3. Remove foil hose and polystyrene pad-
ding from the appliance.
Changing door stop
WARNING!
Before changing the door stop, disconnect the mains plug.
1. Open loading door.
2.
Unscrew hinge A from the front of the
appliance and take off the loading door.
3.
Remove cover plates B . To do this, in-
sert a thin screwdriver into the slots as
shown in the illustration, push down-
wards slightly and pry out the cover
plates.
4.
Use an appropriate tool and exert pressure to unfasten locking block C from the snap-
on fixture, take out and re-insert on the other side having rotated the block through
180°.
5.
Unscrew hinge A from the loading door, rotate through 180°, re-insert on the oppo-
site side and screw down.
6.
Re-insert cover plates B on the opposite site having first rotated them through 180°.
7.
Unscrew cover plates D from the front
of the appliance, rotate through 180°,
screw on the opposite side.
8.
Unscrew door lock E , push down slight-
ly and remove from the front of the ap-
pliance.
9.
Push snap-in button F in and down,
push cover down slightly and remove from front of the appliance.
10.
Change door lock E over to the opposite side, screw down the door interlock.
11.
On the other side, insert cover F and allow snap-in button to lock into place.
12. Insert loading door and hinges into recesses on the front of the appliance and screw
down.
Note regarding contact protection: The appliance is only secure for operations again
once all plastic parts have been inserted.
C
B
B
A
A
E
E
D
D
FF
84
Installation