Operation Manual

SPIN SPEED (T/MIN)

Shorten the drying cycle adequately to the spin speed the laundry was spun previously in

the washing machine. The higher spin speed was, the shorter drying cycle length. Availa-

ble spin speed values (rpm): from

up to (with 200 rpm steps)

This option allows to save time and energy.

BUZZER (ZOEMER)

Audible confirmation of:

– cycle end

– anti-crease phase start and end

– cycle interruption

–error

When active the symbol

is on.

LONG ANTI-CREASE (ANTIKREUK LANG)

Prolongs standard anti-crease phase at the end of the drying cycle to 90 min. When ac-

tive the symbol

is on. This option helps to keep laundry free from creases. Laundry can

be removed at any time during the anti-crease phase.

TIME (TIJD PROGR.)

Operates only with TIME (TIJD PROGR.) PROGRAMME . Allows to set individual time of

drying from minimum 10 min. to maximum of 3 hours (in 10 min. steps).

1. Turn the programme knob to the TIME (TIJD PROGR.) PROGRAMME .

2. Press the TIME (TIJD PROGR.) button repeatedly until the desired programme dura-

tion is shown in the display, e.g.

for a programme of 1 hour and 20 minutes.

DELAY START (STARTUITSTEL)

Allows to delay the start of a drying programme from minimum of 30 min. to maximum

of 20 hours.

1. Select the drying programme and additional options.

2. Press the DELAY START (STARTUITSTEL) button repeatedly until the desired delay start

is shown in the display, e.g.

if the programme has to start after 12 hours.

3. To activate the delay timer, press the START PAUSE (START PAUZE) button. Time to

start elapses in the displayed.

Setting child lock

The child lock can be set to prevent a programme being accidentally started or a pro-

gramme in operation being accidentally changed. The child lock function locks all but-

tons and the programme knob. The child lock can be activated or deactivated by holding

down the LONG ANTI-CREASE (ANTIKREUK LANG) and BUZZER (ZOEMER) buttons simul-

taneously for 5 seconds.

– Before programme is started: Appliance cannot be used

– After programme is started: Programme in operation cannot be changed

Daily use