User manual

Instructions for use

End of Wash Cycle/Removing the Washing

When a wash cycle is completed, the END (ENDE, FIN) light on the

Programme Progress Display comes on.

If RINSE HOLD (SPÜLSTOPP, ARRET CUVE PLEINE) was selected, the indi-

cator lights DOOR (TÜR, PORTE) and END (ENDE, FIN) come on.

1. After a Rinse Hold, the water must first be drained:

– Either turn the programme knob to OFF (AUS, ARRET), then to DRAIN

(PUMPEN, VIDANGE) and press the START/PAUSE (START/PAUSE,

MARCHE/PAUSE) button (the water is drained without spinning),

– turn the programme knob to OFF (AUS, ARRET), then to SPIN

(SCHLEUDERN, ESSORAGE) and press the START/PAUSE (START/PAUSE,

MARCHE/PAUSE) button (the water is drained and the washing is

given a spin; the spin speed can be altered during the spin).

When this stage of the programme is completed, the END (ENDE, FIN)

light comes on.

2. Opening the door.

The door can be opened after the DOOR (TÜR, PORTE) light goes off and

the END (ENDE, FIN) light has come on.

3. Take out the washing.

4. Turn the programme knob to OFF (AUS, ARRET).

5. Close the stopcock.

6. After the wash cycle is completed, pull out the detergent/additives

drawer slightly to allow it to dry. Leave the door slightly open to air the

inside of the washing machine.

Attention! If the washing machine is not used for a long time:

Close the water tap and disconnect the washing machine from the

electricity mains.