LC 53300 EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 CONTROL PANEL . . . . . . . . . . . . . . . . . . . . . . .
ENGLISH 3 1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.aeg.com • The operating water pressure (minimum and maximum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) • The ventilation openings in the base (if applicable) must not be obstructed by a carpet. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. 2. SAFETY INSTRUCTIONS 2.1 Installation • Remove all the packaging and the transit bolts. • Keep the transit bolts.
ENGLISH • The first time you use the appliance, make sure that there is no leakage. 2.2 Use WARNING! Risk of injury, electrical shock, fire, burns or damage to the appliance. • Use this appliance in a household environment. • Obey the safety instructions on the detergent packaging. • Do not put flammable products or items that are wet with flammable products in, near or on the appliance. • Do not touch the glass of the door while a programme operates. The glass can be hot.
www.aeg.com 3.
ENGLISH 7 3.2 Machine rear 1 Transit locking devices 2 Drain hose 3 Electrical lead 24 Inlet hose 1 3 4 3.3 Detergent dispenser drawer Compartment for powder or liquid detergent used for main wash. If using liquid detergent pour it just before starting the programme. Compartment for liquid additives (fabric softener, starch). Any fabric softener or starching additives must be poured into the compartment before starting the wash programme. Prewash detergent is to be added straight into the drum.
www.aeg.com 4. CONTROL PANEL 4.1 Control panel description BAUMWOLLE ECO COTON 1 2 3 4 5 6 1 TIME SAVING button (ZEITSPA- REN/MINUTERIE) 2 ECONOMY button ( ECO) 3 PREWASH button (VORWÄSCHE/ PRÉLAVAGE) 4 START/PAUSE button (START PAUSE/MARCHE PAUSE) 5 DELAY START button (ZEITVORWAHL/DÉPART DIFFÉRÉ) 6 Programme progress display 7 SPIN reduction selector 8 PROGRAMME selector dial 4.
ENGLISH 9 5. BEFORE FIRST USE WARNING! We recommend you to run a wash programme without any load, to clear any residues which may have been left by the manufacturing process. Pour approx. 100 ml of detergent straight into the drum and run a cotton cycle at 60°C. When the programme is finished the machine will be ready to use. Ensure that the electrical and water connections comply with the installation instructions. Remove any material from the drum. 6. DAILY USE 6.
www.aeg.com If required, pour fabric softener into the smaller compartment marked (the amount used must not exceed the «MAX» mark in the drawer). Close the drawer gently. 6.3 Select the required programme by means of the programme selector dial (8) 6.4 Select the spin speed, Rinse Hold or No spin option (7) You can choose the right programme for any type of laundry following the descriptions on the washing programme tables (see «Washing Programmes»).
ENGLISH be selected after choosing the desired programme and before pressing the button 4 . When these buttons are pressed, the corresponding pilot lights come on. When they are pressed again, the pilot lights go off. If an incorrect option is selected, the corresponding indicator lamp flashes for about 2 seconds. For the compatibility among the washing programmes and the options see chapter «Washing Programmes». 6.
www.aeg.com Before you make any change, you must pause the washing machine by pressing the button 4. The programme can be changed as long as the button 4 has not been pressed. Changing a running programme is possible only by resetting it. Turn the programme selector dial to "AUS/ARRÊT" and then to the new programme position. Start the new programme by pressing the button 4 again. switch the machine off by turning the selector dial to "AUS/ARRÊT " position.
ENGLISH Programme/ Temperature Type of laundry Options 13 Description of the programme COTTON 2) (KOCH-/BUNTWÄSCHE COULEURS) 60° - 30° Coloured cotton (normally soiled cotton items) SPIN REDUCTION/NO SPIN(0)/ RINSE HOLD TIME SAVING 1) ECO3) PREWASH DELAY START SYNTHETICS (PFLEGELEICHT SYNTHÉTIQUE) 60°- 30° Synthetic or mixed fabrics: underwear, coloured garments, non-shrink shirts, blouses.
www.aeg.com Programme/ Temperature Type of laundry Options Description of the programme DRAIN (PUMPEN - VIDANGE) For emptying out the water of the last rinse in programmes with the Rinse Hold or No spin option selected. Draining of water Max load: 3 kg SPIN (SCHLEUDERN ESSORAGE) Separate spin for hand washed garments and after programmes with the Rinse Hold option selected. SPIN REDUCTION You can choose the spin speed by turning the spin speed selector to adapt it to the fabrics to be spun.
ENGLISH 7.2 Temperatures for normally soiled white cottons and linen 95° or 90° (e.g. tea cloths, towels, tablecloths, sheets...) 60°/50° 40°-30°Cold Washing a maximum load makes the most efficient use of water and energy. For heavily soiled laundry, reduce the load size. 7.5 Laundry weights for normally soiled, colour fast garments (e.g. shirts, night dresses, pyjamas....) in linen, cotton or synthetic fibres and for lightly soiled white cotton (e.g.
www.aeg.com Lipstick: moisten with acetone as above, then treat stains with methylated spirits. Treat any residual marks with bleach. Red wine: soak in water and detergent, rinse and treat with acetic or citric acid, then rinse. Treat any residual marks with bleach. Ink: depending on the type of ink, moisten the fabric first with acetone1), then with acetic acid; treat any residual marks on white fabrics with bleach and then rinse thoroughly.
ENGLISH manufacturer's instructions. This will help to prevent the formation of lime deposits. 8.2 After each wash Leave the door open for a while. This helps to prevent mould and stagnant smells forming inside the appliance. Keeping the door open after a wash will also help to preserve the door seal. 8.3 Maintenance wash 17 To run a maintenance wash: • The drum should be empty of laundry. • Select the hottest cotton wash programme.
www.aeg.com 8.6 Cleaning the drawer recess Having removed the drawer, use a small brush to clean the recess, ensuring that all washing powder residue is removed from the upper and lower part of the recess. Replace the drawer and run the rinse programme without any clothes in the drum. 8.7 Cleaning the water inlet filter If your water is very hard or contains traces of lime deposit, the water inlet filter may become clogged. It is therefore a good idea to clean it from time to time.
ENGLISH 19 9. WHAT TO DO IF… Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below. During machine operation it is possible that the End pilot light blinks to indicate that the machine is not working: • 1 flash: problem with the water supply. • 2 flashes: problem with the water draining. • 4 flashes: door open.
www.aeg.com Problem Possible cause/Solution The drain hose is squashed or kinked. • Check the drain hose connection. An option or a programme that ends with the water The machine does not still in the tub or that eliminates all the spinning phaempty and/or does not ses has been selected. spin: • Select the draining or spinning programme. The laundry is not evenly distributed in the drum. • Redistribute the laundry.
ENGLISH 21 Problem Possible cause/Solution The machine vibrates is noisy: The transit bolts and packing have not been removed. • Check the correct installation of the appliance. The support feet have not been adjusted • Check the correct levelling of the appliance. The laundry is not evenly distributed in the drum. • Redistribute the laundry. Maybe there is very little laundry in the drum. • Load more laundry.
www.aeg.com Programmes Load (kg) Energy con- Water consumption sumption (li(kWh) tre) Approximate programme duration (minutes) Remaining moisture (%)1) Cottons 60 °C 3 0.9 45 120 53 Cottons 40 °C 3 0.45 45 110 53 Synthetics 40 °C 1,5 0.5 50 80 35 Delicates 40 °C 1,5 0.5 52 70 35 Wool/Hand wash 30 °C 1 0.3 60 75 30 Standard cotton programmes Standard 60 °C cotton 3 0.59 42 127 53 Standard 60 °C cotton 1,5 0.54 38 127 53 Standard 40 °C cotton 1,5 0.
ENGLISH Spin Speed Maximum 1100 rpm Length of: Inlet pipe Drain pipe El. supply cord 130 cm 160 cm 150 cm 23 12. INSTALLATION 12.1 Lifting the machine Be careful when lifting the machine. Incorrect methods of lifting can cause physical injuries and also increase the risk of damage to the machine. Open the door and take hold of the top inside of the door opening. You can also lift the machine by gripping the rear overhang of the top.
www.aeg.com 2. Remove the polystyrene base from the bottom of the appliance. 3. Return machine to it's upright position and remove the power supply cable and the draining and inlet hose from the hose holders on the rear of the appliance. 4. With a suitable spanner unscrew and remove the three screws and their spacers on machine's rear. 5. The three holes must then be plugged with the plastic plug caps supplied in the bag containing the instruction booklet, which can be found inside the drum.
ENGLISH 25 12.3 Positioning Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or furniture. Level the washing machine by raising or lowering the two front feet. If necessary, check the setting with a spirit level. Any necessary adjustment can be made with a spanner. Accurate levelling prevents vibration, noise and displacement of the machine during operation.
www.aeg.com The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer hose specially designed for this type of use. Before connecting up the machine to new pipework or to pipework that has not been used for some time, run off a reasonable amount of water to flush out any debris that may have collected in the pipes. washtub or sink), above the water trap.
ENGLISH 13. ENVIRONMENT CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office.
192991046-FR-DE-382013 www.aeg.
