EN User Manual Washing Machine LM63672F
www.aeg.com CONTENTS 1. SAFETY INFORMATION.................................................................................................3 2. SAFETY INSTRUCTIONS................................................................................................ 4 3. PRODUCT DESCRIPTION.............................................................................................. 5 4. CONTROL PANEL...........................................................................................................7 5.
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.
www.aeg.com • • • • • If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard. Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket. Do not use water spray and steam to clean the appliance. Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects.
ENGLISH • This appliance complies with the E.E.C. Directives. 2.3 Water connection • Make sure not to cause damage to the water hoses. • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage. 2.4 Use WARNING! Risk of injury, electrical shock, fire, burns or damage to the appliance. • Use this appliance in a household only.
www.aeg.com 3.2 Available from your authorized dealer Only appropriate accessories approved by AEG ensure the safety standards of the appliance. If unapproved parts are used, any claims will be invalidated. Fixing plate kit (4055171146) Available from your authorized dealer. If you install the appliance on a plinth, secure the appliance in the fixing plates. Read carefully the instructions supplied with the accessory. Stacking kit Available from your authorized vendor.
ENGLISH 4. CONTROL PANEL 4.1 Control panel description 1 2 3 9 1 2 3 4 5 On/Off button (On/Off) Programme knob Display Start/Pause button (Start/Pause) Delay start button (Delay Start) 8 6 7 8 9 7 6 4 Time saving button (Time Save) Extra rinse button (Extra Rinse) Spin button (Spin) Temperature button (Temperature) 4.2 Display A B Time area: A 5 Programme duration Delay start Alarm codes Message of error Programme is completed.
www.aeg.com Door lock indicator: B You cannot open the appliance door when the indicator is on. You cannot open the appliance door when the indicator flashes. Wait for some minutes before you open the door. You can open the door only when the indicator goes off. Child safety lock: C The indicator comes on when you activate this device. 5. PROGRAMMES 5.
ENGLISH Programme Temperature range Maximum load Programme description Maximum spin (Type of load and soil level) speed Spin 7 kg 1600 rpm To spin the laundry and to drain the water in the drum. All fabrics. 7 kg To drain the water in the drum. All fabrics. 7 kg 1600 rpm To rinse and spin the laundry. All fabrics, except woollens and very delicate fabrics. Reduce the spin speed accordingly to the type of laundry.
www.aeg.com Programme options compatibility Programme 1) 2) ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ 3) ■ 1) If you set Extra Rinse option, the appliance adds some additional rinses. In the Rinse programme, if you set a low spin speed the appliance performs delicate rinses and a short spin. 2) If you set a shorter duration, we recommend that you decrease the quantity of the load.
ENGLISH 11 6. CONSUMPTION VALUES The data of this table are approximate. Different causes can change the data: the quantity and type of laundry, the water and ambient temperature. At programme start the display shows the duration programme for the maximum load capacity. During the washing phase the programme duration is automatically calculated and can be greatly reduced if the laundry load is lower than the maximum load capacity (e.g.
www.aeg.com 7. OPTIONS 7.1 Temperature Set this option to change the default temperature. Indicator = cold water. The indicator of the set temperature comes on. 7.2 Spin With this option you can decrease the default spin speed. The indicator of the set speed comes on. Additional spin options: Rinse Hold • Set this option to prevent the laundry creases. • The relevant indicator comes on. • The washing programme stops with the water in the drum. The drum turns regularly to prevent the laundry creases.
ENGLISH until the indicator comes on/goes off. You can activate this option: • After you press Start/Pause : the options and the programme knob are locked. • Before you press Start/Pause : the appliance cannot start. 13 8.3 Permanent Extra Rinse With this option you can permanently have an extra rinse when you set a new programme. • To activate/deactivate this option press and at the same time until the indicator Extra Rinse comes on/goes off. 9. BEFORE FIRST USE 1.
www.aeg.com 10.3 Check the position of the flap 1. Pull out the detergent dispenser until it stops. 2. Press the lever down to remove the dispenser. 1 2 3. To use powder detergent, turn the flap up. A With the flap in the position DOWN: • Do not use gelatinous or thick liquid detergents. • Do not put more liquid detergent than the limit showed in the flap. • Do not set the prewash phase. • Do not set the delay start function. 5. Measure out the detergent and the fabric conditioner. 6.
ENGLISH The programme starts, the door is locked. The display show the indicator . The drain pump can operate for a short time when the appliance fills water. 10.7 Behaviour of the appliance After approximately 15 minutes from the start of the programme: • The appliance adjusts automatically the cycle time to the laundry you have put in the drum to have perfect washing results in the minimum necessary time. • The display shows the new time value. 10.8 Starting a programme with the delay start 1.
www.aeg.com 10.13 Opening the door when the delay start is active The drum turns regularly to prevent the creases in the laundry. While the delay start operates, the appliance door is locked. To open the appliance door: The door lock indicator door stays locked. is on. The 1. Press button Start/Pause. You must drain the water to open the door: In the display the door lock indicator goes off. 2. Open the appliance door. 3. Close the door and press button Start/Pause. The delay start continues.
ENGLISH 11.1 The laundry load • Divide the laundry in: white, coloured, synthetics, delicates and wool. • Obey the washing instructions that are on the laundry care labels. • Do not wash together white and coloured items. • Some coloured items can discolour with the first wash. We recommend that you wash them separately for the first times. • Button up pillowcases, close zippers, hooks and poppers. Tie up belts. • Empty the pockets and unfold the items.
www.aeg.com 12. CARE AND CLEANING 12.3 Maintenance wash WARNING! Refer to Safety chapters. With the low temperature programmes it is possible that some detergent stays in the drum. Make regularly a maintenance wash. To do this: 12.1 External cleaning Clean the appliance only with soap and warm water. Fully dry all the surfaces. • Remove the laundry from the drum. • Set the cotton programme with the highest temperature with a small quantity of detergent.
ENGLISH 3. 4. 12.6 Cleaning the drain filter Do not clean the drain filter if the water in the appliance is hot. 1. 2. 1 1 2 3. 4.
www.aeg.com 5. 6. 1 7. 2 8. 1 2 9.
ENGLISH 21 12.7 Cleaning the inlet hose and the valve filter 1. 2. 1 2 3 3. 4. 45° 20° 13. TROUBLESHOOTING • - The appliance door is open or not closed correctly. Please check the door! 13.1 Introduction • The start of the appliance does not occur or it stops during operation. - The mains supply is unstable. Wait until the mains supply is stable. • First try to find a solution to the problem (refer to the table). If not, contact the Authorised Service Centre.
www.aeg.com 13.2 Possible failures Problem Possible solution The programme does not start. Make sure that the mains plug is connected to the mains socket. Make sure that the appliance door is closed. Make sure that there is not a damaged fuse in the fuse box. Make sure that the Start/Pause has been pressed. If the delay start is set, cancel the setting or wait for the end of countdown. Deactivate the Child Lock function if it is on. The appliance does not fill with water properly.
ENGLISH Problem 23 Possible solution Make sure that the drain filter is not clogged. Clean the filter, if necessary. Refer to 'Care and cleaning'. Adjust manually the items in the tub and start the spin phase again. This problem may be caused by balance problems. There is water on the floor. Make sure that the couplings of the water hoses are tight and there is not water leakages. Make sure that the drain hose have no damages. Make sure you use the correct detergent and the correct quantity of it.
www.aeg.com 14.
ENGLISH 25
www.aeg.
ENGLISH 27
132895910-B-432015 www.aeg.