User manual

8.3
With this option you can delay the start
of a programme from 30 minutes to 20
hours.
The display shows the related indicator.
8.4
With this option you can decrease the
programme duration.
• Press this button one time to set
'Shortened duration' for items with
daily soil.
• Press this button two times to set
'Extra Quick' for items with almost no
soil.
Some programmes accept
only one of the two options.
8.5
With this option you can add some rinses
to a washing programme.
Use this option for persons allergic to
detergents and in areas where the water
is soft.
The related indicator comes on.
8.6
Set this option to add the stain phase to
a programme.
Use this option for laundry with hard
stains to remove.
When you set this option, put the stain
remover into compartment .
This option increases the
programme duration. This
option is not available with a
temperature lower than 40 °C.
8.7
With this option you can decrease the
default spin speed.
The display shows the indicator of the set
speed.
Additional spin options:
No Spin
• Set this option to remove all spin
phases.
• Set it for very delicate fabrics.
• The rinse phase uses more water for
some washing programmes.
• The display shows the indicator
.
Rinse Hold
• Set this option to prevent the laundry
creases.
• The washing programme stops with
the water in the drum. The drum turns
regularly to prevent the laundry
creases.
• The door stays locked. You must drain
the water to unlock the door.
•
The display shows the indicator .
To drain the water refer to ‘At
the end of the programme’.
8.8
Set this option to change the default
temperature.
Indicator = cold water.
The display shows the set temperature.
9.
BEFORE FIRST USE
1. Put 2 litre of water in the detergent
compartment for washing phase.
This activates the drain system.
2. Put a small quantity of detergent in
the compartment for washing phase.
3. Set and start a programme for cotton
at the highest temperature without
laundry.
This removes all possible dirt from the
drum and the tub.
ENGLISH
13