EN User Manual Washing Machine LP 1480 F
www.aeg.com CONTENTS 1. SAFETY INFORMATION............................................................................................. 3 2. SAFETY INSTRUCTIONS.............................................................................................4 3. PRODUCT DESCRIPTION...........................................................................................6 4. CONTROL PANEL....................................................................................................... 7 5. PROGRAMMES ..
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference. 1.
www.aeg.com • • • • • • • The appliance must be connected to the water mains using the new supplied hose sets, or other new hose sets supplied by the Authorised Service Centre. Old hose sets must not be reused. If the mains power supply cable is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons to avoid an electrical hazard. Before any maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.
ENGLISH • • • • • • electrical ratings of the mains power supply. Do not use multi-plug adapters and extension cables. Make sure not to cause damage to the mains plug and to the mains cable. Should the mains cable need to be replaced, this must be carried out by our Authorised Service Centre. Connect the mains plug to the mains socket only at the end of the installation. Make sure that there is access to the mains plug after the installation.
www.aeg.com 3. PRODUCT DESCRIPTION 3.1 Appliance overview 1 2 3 4 5 1 2 3 4 5 6 7 Worktop Detergent dispenser Control panel Door handle Rating plate Drain pump filter Feet for levelling the appliance 6 7 3.2 Available from your authorized dealer Stacking kit Only appropriate accessories approved by AEG ensure the safety standards of the appliance. If unapproved parts are used, any claims will be invalidated. Fixing plate kit (4055171146) Available from your authorised dealer.
ENGLISH Read carefully the instructions supplied with the appliance and with the accessory. WARNING! Do not put the tumble dryer under the washing machine. 4. CONTROL PANEL 4.1 Control panel description Baumwolle Eco Koch/Bunt Blanc/Couleurs Coton Eco +Vorwäsche Super Eco +Prélavage 20 Min.
www.aeg.com Temperature area: Temperature indicator A Cold water indicator. Spin area: Spin speed indicator B No Spin indicator1) Rinse Hold indicator 1) Only available for Spin/Drain programme. Display indicators: Washing phase Rinses phase Spin phase Child safety lock C Door locked You cannot open the appliance door when the symbol is on. You cannot open the appliance door when the symbol flashes. Wait till the symbols is off before opening the door.
ENGLISH 9 5. PROGRAMMES 5.1 Programme Chart Programme Temperature range Maximum load Maximum spin speed Programme description (Type of load and soil level) Washing programmes Koch/Bunt Blanc/Couleurs Cottons 95°C - Cold 8 kg 1400 rpm White cotton and coloured cotton. Normal soil and light soil. Koch/Bunt + Vor- 8 kg wäsche - Blanc/ 1400 rpm Couleurs + Prélavage Cottons + Prewash 95°C - Cold White cotton and coloured cotton. Heavy soil and normal soil.
www.aeg.com Programme Temperature range Maximum load Maximum spin speed Programme description (Type of load and soil level) Schleudern/ Pumpen - Essorage/Vidange 8 kg 1400 rpm To spin the laundry and to drain the water in the drum. All fabrics, except woollens and delicate fabrics. Spülen - Rinçage Rinse 8 kg 1400 rpm To rinse and spin the laundry. All fabrics, except woollens and very delicate fabrics. Reduce the spin speed accordingly to the type of laundry.
ENGLISH Programme Temperature range Cottons Eco6) 60°C - 40°C 11 Maximum load Maximum spin speed Programme description (Type of load and soil level) 8 kg 1400 rpm White cotton and fast-coloured cotton. Normal soil. The energy consumption decreases and the time of the washing programme is extended. 1) To reduce creasing, this cycle regulates the water temperature and performs a soft wash and spin phase. The appliance adds some rinses.
www.aeg.com Programme ZeitZeit Extra Sparen vorSpülen - Gain wahl - RinDéde part ches1) çage + 2) 3) Temps Différé Flecken Ta- U./ Min. T/Min. Curtains ■ ■ ■ ■ Jeans ■ ■ ■ ■ Quick Intensive ■ ■ ■ ■ 20 min.-3Kg ■ Super Eco ■ ■ Cottons Eco ■ ■ ■ ■ ■ ■ ■ ■ 4) ■ 1) The Stain option is not available with a temperature lower than 40 °C. 2) If you set Extra Rinse option, the appliance adds some additional rinses.
ENGLISH 13 At the start of the programme, the display shows the programme duration for the maximum load capacity. During the washing phase the programme duration is automatically calculated and can be greatly reduced if the laundry load is lower than the maximum load capacity (e.g. Cotton 60°C, maximum load capacity 8 kg, the programme duration exceeds 2 hours; actual load 1 kg, the programme duration will be less than 1 hour).
www.aeg.com • The appliance has a malfunction. To deactivate/activate the acoustic signals, press Flecken - Taches and Extra Spülen - Rinçage + at the same time for 6 seconds. If you deactivate the acoustic signals, they continue operate when the appliance has a malfunction. 7.2 Child Lock With this option you can prevent that the children play with the control panel. • To activate/deactivate this option, press Temp. and U./Min. - T/Min. at the same time until the indicator comes on/goes off.
ENGLISH 8.7 U./Min. - T/Min. With this option you can decrease the default spin speed. The display shows the indicator of the set speed. Additional spin options: No Spin • Set this option to remove all spin phases. • Set it for very delicate fabrics. • To compensate for the absence of spinning, the rinse phase uses more water for some washing programmes. • The display shows the indicator . Rinse Hold 15 • Set this option to reduce creasing. • The washing programme ends with water in the drum.
www.aeg.com 10.3 Filling the detergent and additives A 4. To use liquid detergent, turn the flap down. Compartment for prewash phase, soak programme or stain remover. Compartment for washing phase. B Compartment for liquid additives (fabric conditioner, starch). Maximum level for quantity of liquid additives. Flap for powder or liquid detergent. Always follow the instructions that you find on the packaging of the detergent products. 10.4 Check the position of the flap 1.
ENGLISH • The indicator of Start/Pause Départ/Pause flashes. • The display shows: the default temperature, the spin speed, the indicators of the programme phases and the programme duration. 2. If necessary, change the temperature, the spin speed, the cycle duration, or add available options. When you activate an option, the indicator of the set option comes on. If you set something incorrect, the display shows the message Err. 10.
www.aeg.com Before starting the new programme the appliance could drain the water. In this case, make sure that the detergent is still in the detergent compartment, if not fill the detergent again. 10.12 Opening the door when the programme operates CAUTION! If the temperature and level of the water in the drum are too high, the door lock indicator stays on and you cannot open the door. To open the door proceed as follows: 1.
ENGLISH Press the button Ein/Aus - Marche/ Arrêt to activate the appliance again. • After 5 minutes from the end of the washing programme Press the button Ein/Aus - Marche/ Arrêt to activate the appliance again. The display shows the end of the last set programme. Turn the programme knob to set a new cycle. 19 If you set a programme or an option that ends with water in the drum, the AUTO Stand-by function doesn't deactivate the appliance to remind you to drain the water. 11.
www.aeg.com 11.4 Ecological hints • Always start a washing programme with the maximum load of laundry allowed. • If necessary, use a stain remover when you set a programme with a low temperature. • To use the correct quantity of detergent, check the water hardness of your domestic system. Refer to "Water hardness". use a water softener for washing machines. In areas where the water hardness is soft it is not necessary to use a water softener.
ENGLISH 12.5 Cleaning the detergent dispenser 1. 2. 1 2 3. 4. 12.6 Cleaning the drain filter Do not clean the drain filter if the water in the appliance is hot. Regularly check the drain pump filter and make sure that it is clean. Repeat the steps 2 and 3 until the water stops flowing out.
www.aeg.com 1. 2. 180° 3. 4. 2 2 1 1 5. 6. 7. 8.
ENGLISH 23 Always keep a rag nearby to dry up any water spillage. 12.7 Cleaning the inlet hose and the valve filter 1. 2. 1 2 3 3. 4. 45° 20° 12.8 Emergency drain Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (8) of 'Cleaning the drain filter'. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate the drain system again: 1.
www.aeg.com 13. TROUBLESHOOTING • - The appliance door is open or not closed correctly. Please check the door! 13.1 Introduction • The appliance does not start or it stops during operation. - The mains supply is unstable. Wait until the mains supply is stable. • First try to find a solution to the problem (refer to the table). If the problem persists, contact the Authorised Service Centre. - No communication between electronic elements of the appliance. Switch off and switch on again.
ENGLISH Problem Possible solution The appliance does not fill with water and drain immediately. Make sure that the drain hose is in the correct position. The hose may be too low. The appliance does not drain the water. Make sure that the sink spigot is not clogged. 25 Make sure that the drain hose has no kinks or bends. Make sure that the drain filter is not clogged. Clean the filter, if necessary. Refer to 'Care and cleaning'. Make sure that the connection of the drain hose is correct.
www.aeg.com Problem Possible solution The cycle is longer than the time displayed. An unbalanced laundry load increases the duration time. This is a normal behaviour of the appliance. The washing results are not satisfactory. Increase the detergent quantity or use a different detergent. Use special products to remove the stubborn stains before you wash the laundry. Make sure that you set the correct temperature. Decrease the laundry load. You cannot set an option.
ENGLISH 15. CH 27 GUARANTEE Customer Service Centres Point of Service Industriestrasse 10 5506 Mägenwil Le Trési 6 1028 Préverenges Via Violino 11 6928 Manno Morgenstrasse 131 3018 Bern Zürcherstrasse 204E 9000 St. Gallen Seetalstrasse 11 6020 Emmenbrücke Schlossstrasse 1 4133 Pratteln Comercialstrasse 19 7000 Chur Spare parts service Industriestrasse 10, 5506 Mägenwil, Tel. 0848 848 111 Specialist advice/Sale Badenerstrasse 587, 8048 Zürich, Tel.
132953401-A-162017 www.aeg.