User manual

Something not working?
26
The door cannot be opened
with the DOOR (DEUR) button
Electric mains plug not
connected
Connect the mains plug
Program selector set to
OFF (UIT)
Set a program. The fill-in
door can be opened at
any time by pressing
firmly against the door
(pressing location
)
The door cannot be closed
Fluff filter has not been
inserted correctly and/or
the filter lid not closed
Replace the fluff filter
and ensure the filter lid is
closed
The drum illumination does
not work
The program selector is in
the OFF (UIT) position
Turn the program selector
dial to LIGHT
(VERLICHTING)
The bulb needs replacing Replace bulb
The remaining running time
display changes rapidly.
The remaining running
time is adjusted
automatically depending
on the type of items
being washed, the
washing time and the
degree of dampness.
Automatic process. There
is no unit fault.
The dryer terminates the
drying process automatically:
END (EINDE) is displayed
shortly after program start;
no display of the extent of
drying
Too dry or too little
laundry filled-in for the
selected program
Select time program or
higher drying stage (e.g.
EXTRA DRY (EXTRA-
DROOG) instead of
VERY DRY (INTENSIEF-
DROOG))
The drying process takes
unusually long. 4.5 hours
after the beginning of the
drying process:
- END (EINDE) display is illu-
minated
- acoustic signal sounds
- discontinuation of the
drying process
-
Program run display is flash-
ing
- error code C6 is displayed
SPECIAL CARE (LAGE
TEMPERATUUR) button
pressed and too much
laundry filled-in
Check the program
selection: SPECIAL CARE
(LAGE TEMPERATUUR)
button appropriate only
for laundry amounts up
to 2.5kg
Too much laundry
filled-in
Reduce the amount of
laundry filled-in
Laundry too damp
Pre-dry the laundry more
thoroughly
Symptom Possible cause Solution