User manual

21
Drying results unsatis-
factory.
Wrong programme selected.
Select a different programme
the next time you dry (see
“Overview of programmes”
section).
Lint filter clogged. Clean lint filter.
Heat exchanger clogged
with lint.
Clean heat exchanger.
Incorrect volume of laundry.
Observe recommended load-
ing volumes.
Ventilation slots in base area
covered up.
Uncover ventilation slots in
base area.
Residue on inside surface of
drum or drum ribs.
Clean inside surface of drum
and drum ribs.
Conductance of water at in-
stallation site differs from
standard setting of ma-
chine.
Re-programme standard set-
ting for degree of drying (see
‘Programming options’ sec-
tion).
Loading door does not
close.
Fine strainer not in place
and/or large mesh filter not
locked in place.
Install fine strainer and/or
snap large mesh filter into
place.
When pressing a but-
ton, the corresponding
button flashes several
times.
Washing protection. After
the start of the programme,
the option can no longer be
set.
Turn the programme knob to
OFF (UIT). Set the programme
again.
Drum light does not
work.
Programme selector in OFF
(UIT) position.
Turn programme selector to
LIGHT (VERLICHTING) or to any
programme.
Defective light bulb.
Replace light bulb (see next
section).
Programme inactive,
EMPTY WATER (RESER-
VOIR) display illumi-
nated.
Condensate tank is full.
Empty condensate tank, then
start programme with START/
PAUSE (START/PAUZE) button.
Drying cycle ends
shortly after pro-
gramme starts. END
(EINDE) display illumi-
nated.
Not enough washing load-
ed or washing loaded is too
dry for selected programme.
Select time programme or
higher drying level (e.g. INTEN-
SIVE DRY - INTENSIEF-DROOG
instead of STORAGE DRY -
KAST-DROOG).
Problem Possible cause Remedy