User manual

22
Changing bulb for inside light
Only use a special bulb which is designed specially for dryers. The spe-
cial bulb is available from the after-sales service,
ET-Nr. 112 552 000-5.
1 Warning! Do not use standard bulbs! These develop too much heat and
may damage the machine!
1 Warning! Before replacing the bulb, disconnect the mains plug; with a
permanent connection: fully unscrew or deactivate the fuse.
1. Unscrew covering bonnet from above bulb (this can be found directly
behind the loading aperture, at the top; refer to “Description of ma-
chine” section.)
2. Replace defective bulb.
3. Screw covering bonnet back down.
1 Warning! For reasons associated with safety, the covering bonnet must
be screwed down tightly. If this is not done, the dryer must not be op-
erated.
Drying cycle lasts an
unusually long time.
Note:
After around 5 hours
the drying cycle ends
automatically (see
„Drying cycle com-
plete“).
Lint filter clogged. Clean lint filter.
Heat exchanger clogged
with lint.
Clean heat exchanger.
SPECIAL CARE (LAGE TEMP.)
button pressed and load
volume too big.
SPECIAL CARE (LAGE TEMP.) is
only suitable for use with
loads of up to 3kg!
Load volume too big. Reduce load volume.
Laundry insufficiently pre-
drained.
Laundry must be adequately
pre-drained.
Problem Possible cause Remedy