User manual

What to do if ...
28
If you do not find the required information in this manual to remedy a
disturbance, please call the customer service.
The drum illumination does
not work
The program selector is in
the OFF (AUS) position
Turn the program selector
dial to LIGHT (BELEUCH-
TUNG)
The bulb needs replacing Replace bulb
Display EMPTY WATER
(BEHÄLTER) is lit
Condensate container full
Empty the condensate
container
EMPTY WATER (BEHÄLTER)
indicator illuminated, even
though the container has
already been emptied
Foreign bodies, e. g. ani-
mal hairs, can block the
inlet nozzle as well as the
valve on the end of the
container
With the container pulled
out, switch on the
appliance momentarily.
The blockage can be
removed from the contai-
ner shaft or the hair clea-
ned out of the valve
The dryer terminates the
drying process automatically:
END (ENDE) is displayed
shortly after program start
Too dry or too little
laundry filled-in for the
selected program
Select time program or
higher drying stage (e.g.
EXTRA DRY (EXTRATRO-
CKEN) instead of VERY
DRY (STARKTROCKEN))
The drying process takes
unusually long.
Note: The drying cycle ends
automatically after 3 hours:
- The DRYING and COOLING
indicators will flash
- acoustic signal sounds
The condenser unit is
covered with fluff
Clean the condenser unit
Fluff filter is clogged Clean the fluff filter
SPECIAL CARE (SCHON)
button pressed and too
much laundry filled-in
Check the program
selection: SPECIAL CARE
(SCHON) button
appropriate only for
laundry amounts up to
2.5kg
Too much laundry
filled-in
Reduce the amount of
laundry filled-in
Laundry too damp
Pre-dry the laundry more
thoroughly
Symptom Possible cause Solution