User manual

What to do if ...
25
If after these checks, the tumble dryer still does not work, contact your
local AEG Service Force Centre.
Please note that it will be necessary to provide proof of purchase for
any in-guarantee service calls.
In-guarantee customers should ensure that the above checks have been
made as the engineer will make a charge if the fault is not a mechani-
cal or electrical breakdown.
The door cannot be closed
Fluff filter has not been
inserted correctly and/or
the filter lid not closed
Replace the fluff filter
and ensure the filter lid is
closed
Display EMPTY WATER is lit Condensate container full
Empty the condensate
container
EMPTY WATER indicator illu-
minated, even though the
container has already been
emptied
Foreign bodies, e. g. ani-
mal hairs, can block the
inlet nozzle as well as the
valve on the end of the
EMPTY WATER container
With the container pulled
out, switch on the
appliance momentarily.
The blockage can be
removed from the contai-
ner shaft or the hair clea-
ned out of the valve
The dryer terminates the
drying process automatically:
END is displayed shortly after
programme start
Too dry or too little
laundry is in the drum for
the selected programme
Select time programme or
higher drying stage (e.g.
EXTRA DRY instead of
INTENSIVE DRY)
The drying process takes
unusually long.
Note: The drying cycle ends
automatically after 3 hours:
- The DRYING and COOLING
indicators will flash
The vent hose may be
obstructed
Check the vent is not
blocked or squashed
Fluff filter is clogged Clean the fluff filter
SPECIAL CARE button
pressed and too much
laundry in the drum
Check the programme
selection: SPECIAL CARE
button appropriate only
for laundry amounts up
to 2.5kg
Too much laundry in the
drum
Reduce the amount of
laundry in the drum
Laundry too damp
Pre-dry (spin) the laundry
more thoroughly
Symptom Possible cause Solution