Operation Manual

27
ENGLISH
• Before you use the speakers for the rst time, they
must be charged for approximately 6 hours. Refer to
the section “Charging the built-in batteries of the
speakers”.
Power supply
• Insert the grid plug into a properly installed three
prong socket with 230 V, 50 Hz. Connect the device
with the plug connector by inserting its plug into the
DC IN jack of the device.
• Make sure the grid voltage corresponds to the gures
on the rating plate.
CAUTION:
• Only use the supplied power adaptor for this device.
Do not use for other devices.
• Only use power adaptor with 7.5 V (
), other
adaptors may cause damage to the device.
NOTE:
Disconnect from mains power supply during longer
periods of non-use.
Insert/Replace Battery in Remote Control
NOTE:
Where necessary, the lithium cell in the battery com-
partment of the remote has been tted with a protec-
tive foil for transport. This extends the lifetime of the
battery. Before initial use please remove this foil to
prepare the remote for use.
The battery in the remote is a long-life lithium cell. Should
the range of the remote shorten during use, follow the
steps below:
• Open the battery compartment on the underside of
the remote.
• Replace the cell with a battery of the same type
(CR 2025). Make sure the polarity is correct.
• Close the battery compartment.
If the remote is not in use for a lengthy period of time,
please remove the battery to prevent the battery acid
from “leaking”.
WARNING:
• Do not expose batteries to intense heat or direct
sunlight. Never throw batteries onto a re. Danger
of explosion!
• Keep batteries out of the reach of children. They are
not toys.
• Do not force batteries open.
• Avoid contact with metallic objects. (Rings, nails,
screws etc.) Danger of short circuits!
• Short circuits may overheat or even ignite batteries.
This may lead to combustion.
WARNING:
• When transporting the batteries, cover the terminals
for your safety with an adhesive strip.
• If a battery leaks, do not rub the uid into the eyes
or the skin. If acid comes into contact with the eyes,
rinse with puried water and seek medical advice if
symptoms persist.
CAUTION:
Do not dispose of batteries with household waste. Please
take used batteries to an authorised collection point or
to a dealer.
Explanation of the LED Indications
• Power indication base station (5):
- Unit switched on = LED lights blue
- Unit in standby = LED lights red
• Speaker charge indication (4):
- Not charging = LED not lit
- Charging = LED ashes blue
- Charging completed = LED lights blue
• Power indication speakers (7):
- Speakers switched o (OFF) = LED not lit
- Not connected = LED slowly ashing blue
- Connection being established = LED quickly ash-
ing blue
- Connected = LED lights blue
- Battery weak = LED lights red
• Operation indication transmitter (16):
- Connection being established = LED quickly ash-
ing red
- Connected = LED slowly ashing red
- Transmitting = LED lights red
iPod/iPhone Compatibility
Due to the large variety of iPod and iPhone models and
generations on the market, full compatibility cannot be
guaranteed. Before connecting your iPod/iPhone, ensure
that it has a compatible interface.
Full compatibility of the remote functions also cannot be
guaranteed. Operate your iPod/iPhone as normal, while it
sits in the docking station.
NOTE:
Depending on the software version of your iPhone the
following error message may be displayed:
“This accessory was not developed for iPhone use. It
is possible that noise occurs and signal strength is
reduced.”
In this case press “OK”.