Service manual

SOI 03.06 FV 35/38 599 36 78-45
TEST DATA AT A GLANCE
Parts Symbol Value / Data
Thermal cut-out (OVEN) TC01 145°C
Oven lamp OL 240-250V 25W
High voltage capacitor C 1.02µF AC 2100V
Magnetron MG
Filament < 1
Ω
Filament – chassis
∞ ohm.
Power transformer T
Filament winding < 1
Ω
Secondary winding Approx. 160
Ω.
Primary winding Approx. 2
Ω.
Fuse F1 F20A 250V
Fuse F2 F8A 250V
Thermal cut-out (Magnetron) TC02 125°C
WIRING/RE-WIRING
WARNING: WIRING / RE-WIRING.
Before carrying out any work; carry out 3D
checks.
1. Disconnect the supply
2. Door opened and wedge open.
3. Discharge the high voltage capacitor.
RE-WIRING.
Ensure the following:
1. Wires must not touch:
a) High voltage parts.
(Magnetron, high voltage transformer, high
voltage capacitor and high voltage rectifier).
b) Parts that become hot.
(Heating elements, oven lamp, oven cavity
magnetron and high voltage transformer).
c) Sharp edges.
(Bottom plates, oven cavity, waveguide
flange, chassis support and other metallic
parts).
d) Movable parts.
( Fan blade, any motor, switch).
2. Positive lock connectors are fitted correctly.
Ensure the locking pin is located correctly.
3. Wires are connected correctly as per pictorial
diagram.
4. No wire leads are trapped by the outer wrap.