Service manual

SOI 12.06 FV 35/43 599 37 42-75
COMPONENT REPLACEMENT AND ADJUSTMENT PROCEDURE
CONVECTION MOTOR REMOVAL
1. Remove the one (1) nut and washer from the
convection motor shaft.
2. Remove the convection fan from the convection
motor shaft.
3. Remove the pipe from the convection motor shaft.
4. Remove the two (2) screws holding the convection
motor angle to the convection duct.
5. Remove the cooling fan from the convection motor
shaft.
6. Remove the two (2) screws holding the convection
motor to the convection motor angle.
7. Remove the one (1) ring from the convection motor
shaft.
8. Now, the convection motor is free.
POSITIVE LOCK
®
CONNECTOR REMOVAL
1. CARRY OUT 3D CHECKS.
2. Push the lever of positive lock
®
connector.
3. Pull down on the positive lock
®
connector.
CAUTION: WHEN YOU (SERVICE ENGINEERS)
CONNECT THE POSITIVE LOCK
®
CONNECTORS TO THE TERMINALS,
CONNECT THE POSITIVE LOCK
®
SO
THAT THE LEVER FACES YOU(SERVICE
ENGINEERS).
Figure C-2. Positive lock
®
connector.
OVEN LAMP SOCKET REMOVAL
1. CARRY OUT 3D CHECKS.
2. Remove the wire leads as Positive lock® connector
removal above.
3. Lift up the oven lamp from its retaining clips by
pushing the tab of the air intake duct.
4. Now, the oven lamp is free.
Figure C-3. Oven lamp.
POWER SUPPLY CORD REPLACEMENT
REMOVAL
1. CARRY OUT 3D CHECKS.
2. Remove the one (1) screw holding the green/yellow
wire to the back plate.
3. Disconnect the leads of the power supply cord from
the noise filter, referring to the Figure C-4(a).
4. Release the power supply cord from the rear cabinet.
5. Now, the power supply cord is free.
Figure C-4(a). Replacement of Power Supply Cord.
RE-INSTALL
1. Insert the moulding cord stopper of power supply cord
into the square hole of the power angle, referring to
the Figure C-4(b).
2. Install the earth wire lead of power supply cord to the
back plate with one (1) screw and tight the screw.
3. Connect the brown and blue wire leads of power
supply cord to the noise filter correctly, referring to the
Pictorial Diagram.
Figure C-4(b). Power Supply Cord Replacement.
Positive lock
connector
Terminal
Leve
r
Push
Pull down
Lock
Socket
Bulb
Power supply
cord
Back
p
late
Green/
Yellow wire
Brown wire
Noise filte
r
Blue wire
Power supply cord
Moulding cord stoppe
r
Back plate
Square hole