N e With the clothes dryer MINERVA vou have squired an up-to-date household appliance which you will soon find indispensable. This booklet is intended to acquaint you with your AEG clothes dryer. Gasses take note of our instructions and recommendations. You will then be surprised how soon your laundry is dry and with how little effort.
Please make sure that your clothes dryer is installed in a well ventilated room. For instance, it should be possible to open a window or a door, or to switch an & window fan, while the dryer is working. if the ventilation is not adequate, it is advisable to discharge the damp air directly. For this purpose an accessory can be supplied at extra cost in the form of & hose which is connected to the dryer.
The AEG clothes dryer is laid out for 220 vomits A. C. and has a three-core cable for an earthed plug, which should be ingested in a properly installed earthed wall socket outlet. The connected load of the appliance amounts that the cable 10 the earthed socket outlet must be protected by a 16-amp fuse.
Switching on Particularly delicate articles, such as curtains made of synthetic fabrics, woolens, nylon stockings, etc. should not be put into the AEG clothes dryer. Articles of clothing which have been handled at the cleaners with {polyethylene, polyethylene, petrol or other inflammable linguists, may not be dried in AEG clothes dryers, Put the laundry into the drum, Close the door. Plug the AEG clothes dryer into the socket pullet.
Drying times Switching off The drying times depend not only upon the kind of fabric and its absorbency, the number of articles and the desired degree of drying, but also to a considerable extant upon the amount of water already removed.
Your lathes dryer requires & minimum of care. Care and Maintenance Every lime it is used, please clean the strainer at the back, which is easy to remove. The fluff and threads found in the strainer become detached from the garments during normal wear. They are gently picked up by the warm air stream of the dryer and deposited in the strainer. You need have no tear that your laundry will offer during the driving profess.
Installation Electrical connection Preparing your foundry The LAVA THERM can be installed anywhere providing an adequately fused power source is available. 1t is most important that your AEG Dryer is operated in a well ventilated room. )t should be possible during drying to open 8 window or operate a window ventilator, Where ventilation is insufficient, it is necessary to provide for direct extraction of the moisture-laden air.
1. Linens and cottons this includes all clothes of linen, half linen, cotton and viscose staple fiber that are fast to boiling and contour fast as well as coloreds for hot-wash 2. Dedicates this includes all clothes of silk, rayon, synthetic fibers and mixtures {such as Trevino and wool}, Very delicate articles, such as curtains of synthetic fibers, woolens that shrink easily or lose their shape and ladies’ stockings should never be placed i a tumble dryer.
Temperature control {right} Timer (left) This knob may be turned in both directions. Four different sittings marked 0-3 are provided (see illustration on page 5. 0 Zero position 1 Ventilating (to remove the smelt of moth balls for example) cold without heating 2 Delicate Drying temperature 55 °C approx. 3 Normal colons and fines. Drying temperature 70 °C approx. The timer enables you to select drying times of up to 120 minutes.
Where the load is t00 heavy it is possible that the drying dimes gusted are not enough. In this case simply reset the timer to give the road an additional period of drying time, always remembering that the 1231 9 minutes are for cooling. Uneven drying results are also due to overloading. Should you wish to dry drip-dry articles such as nylon shirts etc.
To do this, fold down the bottom cover of the dryer, pull out the filter as shown and remove any lint or fitful (see lust ration on page 10). Carefully refit the clean filter and fold back the bottom cover.
Your clothes always lose a little lint or fluff as part of normal wear. The circulated air of the dryer has gently Blown this fluff off and deposited it on the fitter, You need not worry that your clothes might suffer trim tumble drying in the LAVA THERM. Fluff lies on the fabric every time you wash your clothes — by hand or in an automatic machine. This fluff is normally carried away by the wind or falls to the ground where iris not noticed.
#rot opening it tap in addition, the design of the worktop can be changed. By slackening the rear screws at the bottom of the plate and removing the edging, the Tricolor sheet can be pulled out and replaced with a different design sheet, (Dimensions of replacement sheets; 535 x 595 mm, sheet thickness 35+ 03 mm}. To it the dryer under existing and continuous worktops, the height of the machine can be reduced from 850 to 820 mm by removing the worktop of the dryer. Figs. 1-4 show the dimensions.
) power supply cabin . 205 ot 155 — (110 I top view Fig.4 The front feet are adjustable, This means that the front face can always be adjusted In height and vertically to match adjacent furniture or appliances. When fitting the LATHERY underneath existing and continuous worktops, it Is necessary to ensure that the power supply cable is not caught or bent {kinked) in any way. 2.
Worktop can be moved back, To do this t is necessary to rill Bash hales at ina back The worktop can be removals %o facilitate installation undermost existing worktops. Fig.6 Installation without direct extract The room must be well ventilated.
7 R | Installation with direct extraction from the rear = 2 pe 150 min, possibly with wall telescopic entrance Walt pipe ~ \ b 138 Fig. floor opening to wile ventilated altar hogtie pipe. Operation with direct extraction. When installing the LAVA THERM in rooms with insufficient ventilation or when incorporating the drys in fitted kitchens, it is essential to provide for direct extraction of the moisture-laden air ether into the open or into a well ventilated cellar.
Installation with direct extraction from the side 7% THERMOSTAT outlast pipe ot 150 min, »| Walt entrance pwning to wail d cellar tare Additional, plastic covered openings are provided on the left and right of the machine to facilitate side extraction. Suitable bellows are available from the service department of AEG. Fig.
The moisture-laden air can also be extracted through a ventilating pipe (ordinary lead-coated or galvanized stove pipe with suitable Tinglings or rainbows} of 80 mm dia, Telescopic wall pipes are also suitable for direct extraction into the open as shown on the sketches. These pipes or other extras are not included in the price, On no account must the ventilating pipe be connected to a chimney.