User manual

10
Press the On/Off button to activate
the cleaner.
To decrease/increase suction, rotate
the On/Off button.
Suction can also be regulated on the
hose handle by opening/closing the
aperture.
Getting the best results
(see page 5)
Carpets: Use the floor nozzle with
the lever in this position.
Hard floors: Use the floor nozzle
with the lever in this position.
Loose rugs/curtains/lightweight
fabrics: Reduce the suction power.
Use the floor nozzle for loose rugs
and the upholstery nozzle for
curtains, cushions etc.
Lamps, pictures and bookshelves:
Use the dusting brush.
Confined areas: Use the crevice
nozzle for crevices, corners and
radiators.
Dust bag indicator and
changing the dust bag
(see page 5)
For peak performance the dust bag
must be changed when full. If the
dust bag should accidentally get
broken in the cleaner, take cleaner to
an AEG Service Centre for cleaning.
Check the dust bag regularly and
replace when necessary. The dust bag
indicator window will gradually turn
red when filling and completely red
when full.
To check the dust bag, the cleaner
must be switched on, with all
attachments connected and off the
floor.
The dust bag full indicator may
signify that the bag is blocked
(occasionally caused by very fine
dust) which will cause loss of
suction and may result in
overheating. If this occurs change
the dust bag even if it is not full.
To change the dust bag:
A Release catch and swing back lid
before removing the dust bag, bend
the tab into the hole to prevent dust
escaping.
B Remove the dust bag.
C Insert new dust bag by fitting the
bag slots over holders.
We recommend the dust bag is
changed:
after using a carpet cleaning powder
if there is a bad smell from the
cleaner, then you should also
change the filter
Note: Use only AEG original dust
bags and filters (ref E51)
Dust bag safety device
To avoid damaging the cleaner do
not use it without a dust bag. A
safety device is fitted which
prevents the cover closing without a
dust bag. Do not attempt to force
cover shut.
Changing the filters (see
page 5)
There are two filters inside your
cleaner. Never use the cleaner
without the filters in place.
To clean Motor Protection filter:
The Motor Protection filter should
be cleaned when dirty.
Release catch, remove lid and filter.
Wash filter in warm water.
Allow to dry and re-insert clean
filter. Close lid.