Instruction manual

- 20 -
1. Replacing Battery
In order to ensure proper functioning of the steering wheel remote control. Please make
sure only use 2 x AAA type battery.
If the device to be controlled no longer responds to any key press even under favourable circumstances
or the device to be controlled indicates a weak battery, please replace the battery of the remote control.
Remove the remote control from the steering wheel as show in P1 & P2.
Push the battery compartment lid on the back of the remote control in direction of the gap and open
the battery compartment.
Remove the dry battery, and replace with 2 new AAA battery.
2. Mounting the Steering Wheel Remote Control
In order to improve adhesion in the case of steering wheels
with large internal diameter, use a foam rubber pad and
bond it to the base compartment lid of the remote control
before installation.
Step. 2
Step. 3
Base
Compartment
Step.1
3. Key functions
Key
Function
1. MUTE
Press this button to mute the audio volume
2. MODE
Press this button to select different mode of the main unit.
3. EJECT
Press this button to stop the CD playback and eject the CD.Please make sure flip down the full panel
first before pressing this eject button, otherwise may cause permanent damage to the unit CD
mechanism.
4.
Press this button to pause disc playback. Press this button again to resume disc Playback.
5. BAND
Press this button to change the radio band.
6. DISP
7. AUDIO (A)
8.
9.
10.
11.
Press this button to increase the volume
Press this button to decrease the volume
Short press this button to change the display mode.
Short press this button to enter into the Audio menu, long press this button to enter into the system
Menu.
Short press for tuner seek down or CD track down.
Short press is tuner seek up or CD track up.
b
a
a
b
a
b
Step 1. Open the locking cover on the rear side of the remote control.
Step 2. Hold the remote control inside the steering wheel and guide the strap thru & under the locking cover.
Step 3. Tighten the strap slightly and then press it with the perforation firmly into the matching catches on the locking
cover. Press Down the locking cover.
Step 4. Close the locking cover and then push it in the direction of the lock position.
Step 5. Release the locking cover. Now the lever should engage firmly through the tension of the strap. If the locking cover
should not engage, or the remote control should not fit firmly enough on the steering wheel, please repeat steps 3-5.
P 1.
P 2.
Battery Insert Guide
When you insert the battery , remember always put the rope wrap around the
battery as show in P.3 . This can help to remove the batteries easily in the
future.
Step. 4
a
b
Rope
P 3.
11.STEERING WHEEL REMOTE