User's Manual

English
69
LINE IN jack (back of the unit)
Forconnectinganalogueplaybackunits.Youcanalsousethisjacktolistentoaudiooutput
from other playback units such as an MP3 player, a CD player etc. via a speaker.
1. ConnectanexternalunittotheLINEINjackusinga3.5mmstereocinchconnector.
2. The unit switches automatically to LINE IN mode. The radio sound is switched off.
3. Listentotheaudioplaybackfromanexternaldeviceviathespeaker.UsetheVOLUME
control (5) to adjust the volume.
4. Forfurtherinstructions,pleaserefertotheusermanualoftheexternalaudiosource.
NOTE:
• Setthevolumeoftheexternaldevicetoareasonablelevel.
• NoalarmbuzzercanbeheardifacableisconnectedtotheLINEINjack!
Cleaning
CAUTION:
Do not dip the appliance in water.
• Removetheplugbeforecleaning.
• Cleantheappliancewithaslightlyhumidclothwithoutanyadditives.
Trouble-shooting
Problem Cause Solution
The unit cannot be oper-
ated
The unit is blocked and
“hangs”
Pull the mains plug for ap-
proximately5seconds.Then
connect the unit again
No alarm buzzer can be
heard
A cable is connected to the
LINE IN jack
Disconnect the cable from
the LINE IN jack
Time/alarm time cannot be
set
The unit is searching for a
radio signal (the lines on the
“ ” symbol flash)
Set the time/alarm time
whilst the unit is switched on
Alarm time/Projection can-
not be switched on/off
The unit is searching for a
radio signal (the lines on the
“ ” symbol flash)
Switch the alarm time/pro-
jection on or off whilst the
unit is switched on