Operation Manual

ManualsBrandsAEG ManualsAudioMRC 4148 DAB plus

English

MRC4148DAB+_IM 26.02.16

• Conﬁrm your selection or input with the SELECT / SNOOZE /

SLEEP button.

Setting the Alarm Time

1. Turn the device on.

2. Keep the MENU button pressed. The display shows “Full

Scan” in DAB operation and the “Software version” in

FM or AUX operation.

3. Press the MENU button repeatedly until “Set Alarm”

appears.

4. Press the SELECT / SNOOZE / SLEEP button. The display

shows “Choose Alarm” and “Alarm1”. Select “Alarm1”

or “Alarm2”.

5. Press the SELECT / SNOOZE / SLEEP button. “Alarm1

Status” appears in the display. The display shows “OFF”.

6. Select the setting “ON”.

7. The display shows “Alarm1 Time Set”. Now set the alarm

time.

8. Alarm1 Type: Select the desired wake-up source. Select

from: BEEPER (beep), DAB, FM.

NOTE: Important!

If you select DAB or FM, do not forget to tune to the

desired station. The unit turns on with the station

received last.

NOTE:

If DAB or FM reception is not available, you are woken

by the buzzer. The display also shows “Not available”.

9. Alarm1 Volume: Now select the volume for the wake-up.

10. Alarm1 Modus: Select the time for the wake-up time

to be active. Select from: Daily, Weekdays, Weekends,

Once.

11. Then set the unit to standby.

The activated alarm function is indicated in the display by “ “.

When the alarm time is reached, the volume of the alarm

signal (DAB, FM, or beep) increases slowly to the set volume.

The volume and the station cannot be changed at a later

time.

NOTE:

If you should use both alarm times, only one alarm symbol

is displayed because of technical reasons.

Switching off the Alarm Signal

Press the POWER button to switch off the alarm signal.

Automatic Alarm Interval

The automatically set alarm function can be switched off for 6

minutes with the SELECT / SNOOZE / SLEEP button.

NOTE:

An activated snooze function is shown in the display by the

symbol “Z “.

Deactivate the Alarm Function

1. Proceed as shown in steps 1 to 5 of “Setting the Alarm

Time”.

2. Select “OFF” with the

/ TUNE + /

/ TUNE – buttons.

Conﬁrm with the SELECT / SNOOZE / SLEEP button.

Cleaning and maintenance

CAUTION:

Do not immerse the device in water.

• Disconnect the mains plug before cleaning.

• You may wipe off external stains, using a slightly damp

cloth without any additives.

Troubleshooting

Problem Cause Solution

The unit

cannot be

operated

The unit is

blocked and

“hangs”

Switch the unit off

using the ON OFF

switch. Wait for

approx. 5 seconds

before switching the

unit on again.

Reset the device to

the factory defaults.

see “Resetting the

unit to the factory

settings”

No DAB Radio

reception

Telescopic an

tenna incorrectly

aligned

Fully extend the

telescopic antenna

and align it vertically.

No Digital Radio

can be received

in your area

Problems with

DAB radio

reception

Depending on

the location, you

may not be able

to receive some

stations at all or

with interference

in your region.