Operating Instructions and Installation Instructions
33
Installation - for contractors
INSTALLATION
7.
Only a qualied contractor should carry out installation,
commissioning, maintenance and repair of the appliance.
7.1
We guarantee trouble-free function and operational relia-
bility only if original accessories and spare parts intended
for the appliance are used.
!
You
.
7.2
Note
-
The specic electrical resistance of the water must not fall
below that stated on the type plate. In a linked water net-
work, factor in the lowest electrical resistance of the water
(see chapter "Specication / Data table"). Your water sup-
ply utility will advise you of the specic electrical water
resistance or conductivity.
8.
8.1
The following are delivered with the appliance:
◦ Sieve inside the cold water inlet
◦ Special aerator "SR"
◦ Connection hose 3/8, 500 mm long, with gaskets*
◦ Tee 3/8*
◦ Company logo for oversink installation
◦ *for the connection as pressure-tested appliance
8.2 Accessories
◦ SR 3: Part number 289591
for MTE 350 and MTE 440
◦ SR 5: Part number 270582
for MTE 570 and MTE 650
* For use in thread M22/M24.
◦ AHS 50 Sensor tap for washbasins
◦ AHo 40 MTH Wall mounted tap for oversink
installation
◦ AHu 40 MTH Twin lever basin tap
◦ AHEu 40 MTH Mono lever basin tap
◦ ADS 40 Sensor tap for washbasins