Operating Instructions and Installation Instructions

Operation - for users and contractors
28
!
Material losses
Ensure that the non-pressurised appliance is not
exposed to any pressure as this could cause irrep-
arable damage:
» Only use the special aerator provided.
» Never use aerators or hoses with aerators.
» Never seal the tap outlets.
» Prevent scale build-up at the tap outlets (see
chapter "Cleaning, care and maintenance").
2.3 Test symbols
See type plate on the appliance.
Country-specic approvals and certications:
Germany
In line with [German] State Building Regulations, a
general test certicate has been issued for these ap-
pliances, as verication of their suitability regarding
noise emissions.
HOL
DIN 4109
P-IX 6837/I
AEG
3. Appliance description
The hydraulically controlled, non-pressurised small in-
stantaneous water heater heats the water directly at the
draw-off point. The heating system starts automatically
when the tap is opened. The short pipe runs ensure that
energy and water losses are minimal.
The DHW output depends on the cold water temperature,
the heating output and the ow rate.
The bare wire heating system is suitable for hard and soft
water areas. This heating system has a low susceptibility
to scale build-up. The heating system ensures quick and
efcient DHW provision at the hand washbasin.
Fitting the special aerator supplied provides an optimum
water jet.