Instruction Manual

4. BEFORE FIRST USE
WARNING!
Refer to the Safety chapters.
4.1 Initial Cleaning
• Remove all parts from the appliance.
• Clean the appliance before first use.
Refer to chapter "Care and
Cleaning".
4.2 Setting the time
You must set the time before you
operate the oven.
When you connect the appliance to the
electrical supply or after a power cut, the
indicator for the Time of Day function
flashes.
Press the + or - button to set the correct
time.
After approximately five seconds, the
flashing stops and the display shows the
time of day you set.
To change the time, press
again and again until the indica-
tor for the Time of Day function
flashes. You must not set the Du-
ration
or End function at
the same time.
To use the appliance, push the control
knob. The control knob comes out.
4.3 Preheating
Preheat the empty appliance to burn off
the remaining grease.
Preheat the two ovens. Heat up one
oven at a time.
Set the functions listed below, if applica-
ble.
1.
Set the function and the temper-
ature to 250°C.
2.
Let the appliance operate for one
hour.
3.
Set the function and the temper-
ature to 250°C.
4.
Let the appliance operate for ten mi-
nutes.
5.
Set the function and the temper-
ature to 250°C.
6.
Let the appliance operate for ten mi-
nutes.
Accessories can become hotter than
usually. The appliance can emit an odour
and smoke. This is normal. Make sure
that the airflow is sufficient.
5. DAILY USE
WARNING!
Refer to the Safety chapters.
5.1 Activating and
deactivating the top oven
1.
Turn the knob for the top oven func-
tions to an oven function.
2.
Turn the knob for the top oven tem-
perature to a temperature.
The power indicator comes on while
the appliance operates.
The temperature indicator comes on
while the temperature in the appli-
ance increases.
3.
To deactivate the appliance, turn the
knob for the top oven functions and
the knob for the top oven tempera-
ture to the Off position.
ENGLISH 7