User's Manual

27
Open/save data
MAIN MENU FUNCTION
Language selection operating language
Load/store data load and store data
Set points/characteristics set point processing
Parameter display and modification of parameters
Operation display select operation display
Last function energy and operating hours
TAB. 6 LBA MAIN MENU
3.1.3 LBA SUBMENUS
The first six lines of the above main menu contain the names of the sub-menus. These are shown
below, with explanations, in the sequence they are contained in the menu.
= Main menu (appears after plugging in the LBA)
Set points/curve
Sprache/language
Menu
Submenu
next
submenu
Default
Value
User
Value
Remarks
Parameters
Sprache/language
Deutsch x
English
Francais
Open/save data Loading, storing, copying of parameter sets
Thyro-P -> LBA 1
LBA -> Thyro-P 2 Parameter from LBA-EEPROM to Thyro-P RAM
Store in LBA Parameter from LBA-RAM to LBA-EEPROM
Save Thyro-P Parameter from Thyro-P RAM to Thyro-P EEPROM
1 Open data again
Thyro-P -> LBA Store parameters from Thyro-P in LBA
waiting time
Observe waiting time! OK key during charging releases
the parameter lock
ASIC-SW Shows production date of controller software
Code LBA Shows version of LBA software
2 Save data again
LBA -> Thyro-P Store parameters from LBA in Thyro-P
waiting time Observe waiting time!
Set points/curve Remark: Display is refreshed after max. 10 sec.
motor pot. 0 Display and modification set point 4
Term. (10) Display set point 1
Term. (11) Display set point 2
Master(bus) Display set point 3 (bus)
Act.pwr.tot:xx,xxmA Display total set point
Absolute set points During active circuit set point is displayed
in a submenue depending on control mode
STD,LOC,REMOTE,ANA STD Choice of set point inputs
ADD,IADD, PRO,IPRO ADD
SW1+SW2, SW1-SW2, SW1*SW2%/100%, SW1*(1-SW2%/100%)
5V,10V,mA term(10) mA Selection signal type for set point 1*
5V,10V,mA term(11) 5V Selection signal type for set point 2*
Ctrl.start 1 4.00mA 0.3mA Control start set point SW1
Ctrl.end1 20.00mA 20.0mA Control start set point SW1
Ctrl.start2 20.00V 0.07V Control start set point SW2
Ctrl.end 2 10.00V 5.0V Control end set point SW2
* refer to ”ATTENTION” on page 16
Adress
Bus+LL-compound xxx 100 xxx for fibre optic 001 - 998
in case of Profibus DP 001 - 125
000 and 999 have specific functions
Main menu