User's Manual

3.1.9 LBA SUBMENUS WITH PASSWORD PROTECTION

REMARK

After password input, further parameters may be modiﬁ ed. These are mainly adjusting parameters

required for achieving power control speciﬁ cations. The modiﬁ cation of these parameters requires

extended specialist knowledge (for instance by training) and is not required under normal circum-

stances.

3.2 CABINET INSTALLATION KIT (SEK)

Using the cabinet installation kit, the LBA may be installed in switching cabinet doors with a thick-

ness of up to 4 mm. It consists of an adaptor frame 96x72mm (cut-out dimensions 92x68mm) and

a cable. Using the cable, the LBA is connected to the RS 232 interface of Thyro-P.

The LBA locks in the adaptor frame and may only be removed with the cabinet door open. This

enables an instructed specialist to set parameters (for instance adjustment to changing tools) and

manual setting of set points (motor potentiometer) as well as for reading the actual value display

without opening the cabinet door (VBG4). In order to avoid the accidental input of data by touch-

ing the LBA, there is a self-activating parameterizing lock to enable (see Table 5).

If the LBA is connected to the Power Controller using a longer cable and does not operate, then

this may possibly be remedied by increasing the supply voltage (open the jumper R 155 in the

control device).

ATTENTION

In case of open jumper R 155, the LBA may not be connected to the Power Controller without

cable (hazard of destruction). The position of the jumper on the control device PCB can be found in

the component mounting diagram (Fig. 10, page 45).

3.3 THYRO-TOOL FAMILY

Thyro-Tool Familiy is an optional software for commissioning and visualization under Windows

95/98/NT 4.0/XP and higher. It includes all functions of Thyro-Tool P and it is connected to Thyro-P

via either one of the two standard interfaces (RS 232 respectively ﬁ bre optic).

FIG. 8 CABINET

INSTALLATION KIT