Operation Manual

Hem
Hem
Presser foot: Hem foot
Stitch selection: “1”
Stitch length: 1-4
1. Replace the normal foot by a hem foot.
2. Turn up the selvage about 3 mm as shown
on the right side.
3. To protect the selvage you have to take in 5
mm from the selvage. For a short moment, stop
the machine with the needle in a horizontal
position.
4. Pull the selvage into the hem foot and start
the automatic hemming.
During hemming, fold the material slightly to the
left and let the selvage run through the foot as
wide as you can.
Button sewing
Button sewing
Presser foot: button foot
Stitch selection: “3” about “7”
Stitch length: 0
The button hole foot is for sewing buttons
up to an average size. Insert the foot.
Clamp the button by lifting and lowering the
presser foot (needle is in a horizontal position).
You have to set the needle stop so that the
button holes were directly hit by the needle.
The first stitches should be steered by the
hand wheel to avoid a damaging of the needle.
15
Bedienungsanl.1800/1600 GB 30.08.2004 17:45 Uhr Seite 17