Gefrierschranke ÖKO-ARCTIS SUPER 2073-4 GS ÖKO-ARCTIS 204-4 GS Congelateurs Diepvriezer Freezer Bedienungsanleitung Mode d’emploi Gebruiksaanwijzing Instruction booklet 2222 059-61
WARNINGS GB It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety.
Installation ª During normal operation, the condenser and compressor at the back of the appliance heat up considerably. For safety reasons, minimum ventilation must be as shown in the relevant Figure. Attention: keep ventilation openings clear of obstruction. ª If the appliance is transported horizontally, it is possible that the oil contained in the compressor flows in the refrigerant circuit.
INSTALLATION Location Place the appliance as far away as possible from sources of heat, e.g. radiators, heaters, direct sunlight, etc. Best performance is obtained with ambient temperature between +18°C and +43°C (class T); +18°C and +38°C (class ST); +16°C and +32°C (class N); +10°C and +32°C (class SN). The class of your appliance is shown on its rating plate.
Important It is essential that the appliance be connected to an efficient earth tap. For this purpose the supply cable plug incorporates a special earth contact. If the sockets of your domestic wiring system are not earthed, have the appliance connected to a separate earth wire by a qualified electrician in accordance with existing safety regulations. The Manufacturer declines all responsibility if the above safety precautions are not observed.
Door reversibility Fig. 2 Unplug the freezer before performing the following operations: F E Remove the ventilation grill (D). F Remove the lower hinge (E) by loosening the two fastening screws. F D F PR185 Fig. 3 Remove the door by sliding it out of the upper pin (AFig. 3). Unscrew the pin and the washer (A+B-Fig. 3) and refit them on the opposite side. C B A Refit the door. Refit the lower hinge (E-Fig. 2) on the opposite side by means of the two screws that have been previously removed.
USING YOUR FREEZER GB This freezer has been marked with the symbol, which means that it is suited to the freezing of fresh foods, the conservation of frozen foods and the production of ice-cubes. The control panel (Fig. 5) 4 1 3 A BC D 2 E Fig. 5 A. Temperature alarm light B. Quick-freezing indicator light C. N/S knob D. Function indicator light E.
Freezing food Set the freezer to quick-freezing operational status. Wait at least 3 hours before introducing fresh foods into the freezer if it has only recently been turned on. If the freezer has already been working for some time, turn the respective knob to the «S» position at least 24 hours before introducing the food into the freezer in order to ensure better freezing results. This period of time may be shortened according to the quantity of food.
Frozen food storage When the freezer is being turned on for the first time, or after a prolonged period of disuse, turn the N/S knob to the Quick-freezing position and then wait at least two hours before introducing the food to be conserved. You may then return the knob to the «N» position. This two-hour waiting period may be avoided if the freezer has already been in operation.
MAINTENANCE Unplug the appliance before carrying out any maintenance operation. GB Idle periods During periods when the appliance is not used, you should take the following precautions: Warning This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians.
AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg Copyright by AEG H 271 271 300 - 0797/03 - 151 2222 059-61 ET 1 2 3 4 5 6 7 8 9 10 11 12 / 97