User manual

55
Important
The wires in the mains lead are coloured in
accordance with the following code:
Green and Yellow - Earth
Blue - Neutral
Brown - Live
If you fit your own plug, the colours of the
wires in the mains lead of your appliance
may not correspond with the markings
identifying the terminals in your plug, proceed as follows:
Connect the green and yellow (earth) wire to the terminal in the plug
which is marked with the letter «E» or the earth symbol or coloured
green and yellow.
Connect the blue (neutral) wire to the terminal in the plug which is
marked with the letter «N» or coloured black.
Connect the brown (live) wire to the terminal in the plug which is
marked with the letter «L» or coloured red.
The plug moulded on to the lead incorporates a fuse. For replacement, use
a 13 Amp BS1362 fuse. Only ASTA or BSI approved fuses should be used.
The plug must not be used if the fuse cover/carrier is lost. The
cover/carrier is indicated by the coloured insert at the base of the plug.
A replacement cover/carrier must be obtained from your local AEG Service
Centre.
Permanent connection
In the case of a permanent connection it is necessary that you install a
double pole switch between the appliance and the electricity supply
(mains), with a minimum gap of 3 mm between the switch contacts and
of a type suitable for the required load in compliance with the current
electrical regulations.
The switch must not break the yellow and green earth cable at any
point.
This operation has only to be performed by a qualified electrician.
54
Building-in
This appliance has been designed to
be built into the kitchen furniture.
The recess should have the dimen-
sions shown in picture A.
Preparation and assembly of the door
The machine is originally pre-
arranged for the assembly of a
door opening from right to left.
In this case it is sufficient to screw
in the hinges (1) and the counter-
magnet (6) provided with the appli-
ance, at the right level (Fig. B).
a) Door
The dimensions of the door should
be:
- width 595-598 mm
- thickness 16-22 mm
The height (C-Fig. C) depends on the height of the adjacent furniture's base.
b) Hinges
To mount the hinges it is necessary to
drill two holes (dia. 35 mm, depth
12.5-14 mm) on the inner side of the
door. The distance between the holes
hobs fixing centres must be 416 mm.
The distance (B) from upper edge of
the door to the centre of the hole
depends on the adjacent furniture's
dimensions.
The required dimensions are given in the picture C.
The hinges will be fixed to the door by means of screws for wood (2-Fig. B)
supplied with the appliance.
820 min
600 min.
600
596
416
176
,
5
818
541
195
490
160
120
90
8
515
165
A
4
1
2
3
6
1
2
3
5
7
8
B
35 Ø 12.5-14 depth
16-22
B
C
22+1,5
595-598
416
C
Installation
GREEN & YELLOW
13 AMP FUSE
CORD CLAMP
BLUE
13 AMP
BROWN