User manual

43
Preparation of Ice Cubes
1. Fill the ice cube tray 3/4 full with cold water, place it in the freezer
compartment and leave to freeze.
2. To loosen the frozen cubes, either bend the ice cube tray or hold it
under running water for a few seconds.
Important! Never try to free an ice tray that is frozen to the freezer
compartment using pointed or sharp edged objects. Use the ice scra-
per supplied.
Defrosting
Refrigerator
Frost is automatically eliminated from the evaporator of the refrigera-
tor compartment every time the motor compressor stops, during nor-
mal use. The defrost water drains out through a trough into a special
container at the back of the appliance, over the motor compressor,
where it evaporates.
Freezer
The freezer compartment, however, will become progrssively covered
with frost. This should be removed with the special plastic scraper
provided, whenever the tickness of the frost exceeds 4 mm. During
this operation it is not necessary to switch off the power supply or to
remove the foodstuffs.
However when the ice becomes very thick on the inner liner, comple-
te defrosting should be carried out as follows:
1. Remove the frozen food from
the freezer, wrap it in several
layers of newspaper and put it
in a very cool place.
2. Switch off the appliance and
pull out the plug, or remove or
unscrew the safety fuses.
3. Leave the freezer compart-
ment door open.
4. Place a basin on the top shelf
of the refrigerator compart-
ment, under the draun hole, lift
the plug as shown in fig..
PR151