User manual

4
Safety
Please read this instruction book before using the appliance and retain
for future reference. These warnings are provided in the interests of your
safety, ensure you understand them fully before using the appliance.
Intended use
• The appliance is intended for use in the home. It is suitable for the
cooling, freezing and storage of frozen food, as well as for making
ice. If the appliance is used for purposes other than those intended
or used incorrectly, no liability can be accepted by the manufacturer
for any damage that may be caused.
Alterations or changes to the appliance are not permitted for reasons
of safety.
Prior to initial start–up
• Check the appliance for transport damage. Under no circumstances
should a damaged appliance be plugged in! In the event of damage,
please contact your retailer.
Refrigerant
The refrigerant isobutane (R600a) is contained within the refrigerant
circuit of the appliance, a natural gas with a high level of environ-
mental compatibility, which is nevertheless flammable.
During transportation and installation of the appliance, be certain that
none of the components of the refrigerant circuit become damaged.
• If the refrigerant circuit should become damaged:
– avoid open flames and sources of ignition;
– thoroughly ventilate the room in which the appliance is situated.
Safety of children
• Keep packaging material away from children.
• Please make old appliances unusable prior to disposal. Pull out the
mains plug, cut off the mains cable and remove any locks or cat-
ches, to prevent young children being trapped inside.
Do not allow children to tamper with the controls or play with the product.
Daily Operation
• Containers with flammable gases or liquids can leak at low tempe-
ratures. There is a risk of an explosion! Do not store any containers
with flammable materials such as, for example, spray cans, fire
21
Levelling the appliance
Place the appliance on a flat
hard floor. Two adjustable feet
on the front of the appliance
enable it to be accurately level-
led by screwing them in or out
as required.
Reversing the door
The side the door opens can be changed from the right side (factory
fitted) to the left side.
Warning! When changing the side the door opens, the appliance
must not be connected to the mains. Remove plug from the mains
before reversing the door.
AEG70
D594
Rear spacers
Fit the rear spacers contained
in the documentation bag to
ensure escape of heat genera-
ted during operation. Proceed
in the sequence illustrated in
figures.
Proceed as follow:
1. Pull off ventilation grille (D)
and remove cover (G).
2. Remove blanking cover (F)
from ventilation grille by
pushing it in the direction of the
arrow and refit it on the oppo-
site side.
3. Unscrew the bottom hinge and
remove the freezer compart-
ment door by pulling it
downwards.
F
D
PR185
F
F
F
E
E
G