User manual

Preparation of Ice Cubes

1. Fill the ice cube tray 3/4 full with cold water, place it in the freezer

compartment and leave to freeze.

2. To loosen the frozen cubes, either bend the ice cube tray or hold it

under running water for a few seconds.

Important! Never try to free an ice tray that is frozen to the freezer

compartment using pointed or sharp edged objects. Use the ice scra-

per supplied.

Defrosting

Refrigerator

Frost is automatically eliminated

from the evaporator of the refrigera-

tor compartment every time the

motor compressor stops, during

normal use. The defrost water

drains out through a trough into a

special container at the back of the

appliance, over the motor compres-

sor, where it evaporates.

We particulary recommend that

you peridically clean the

defrost-water drainage outlet,

located in the center of the

drainage groove in the refrigera-

D037

tor compartment, to prevent the defrost water form overflowing

on to foods stored in the compartment. Use a special cleaner

provided, which you will find already inserted into the dis-

charge hole.

Freezer

The freezer compartment, however, will become progrssively covered

with frost. This should be removed with the special plastic scraper

provided, whenever the tickness of the frost exceeds 4 mm. During

this operation it is not necessary to switch off the power supply or to

remove the foodstuffs.

However when the ice becomes very thick on the inner liner, comple-

te defrosting should be carried out as follows: