User manual

Prior to Initial Start–Up

• Please clean the appliance interior and all accessories prior to initial

start-up (see section: “Cleaning and Care”).

Electrical Connection

Any electrical work required to install this appliance should be carried

out by a qualified electrician or competent person.

WARNING – THIS APPLIANCE MUST BE EARTHED

The manufacturer declines any liability should these safety mea-

sures not be observed.

Before switching on, make sure the electricity supply voltage is the

same as that indicated on the appliance rating plate. The rating plate

is inside, on the left.

The appliance is supplied with a 13 amp plug fitted. In the event of

having to change the fuse in the plug supplied, a 13 amp ASTA appro-

ved (BS 1362) fuse must be used.

on the opposite side.

10. Refit ventilation grille (D), clipping it

into place.

11. Unscrew the handle. Refit it on

opposite side after having pierced

the plugs with a punch. Cover the

holes left open with the plugs con-

tained in the documentation pack.

Attention:

After having reversed the opening

direction of the doors check that all

the screws are properly tightened

and that the magnetic seal adheres

to the cabinet. If the ambient tem-

perature is cold (i.e. in Winter), the

gasket may not fit perfectly to the

cabinet. in that case, wait for the

natural fitting of the gasket or acce-

lerate this process by heating up

the part involved with a normal

hairdrier.

PR24

PR228