User manual

13/23
USE OF THE SIDE PLATES
The width of the seat in which the
coffee machine should be inserted is
determined by the thickness of the
cabinet’s sides. To compensate the
different possible measurement, the
appliance is equipped with 6 plates, 4
are 2mm in thickness and 2 are 1mm.
thick. They should be used to
compensate the internal width of the
seat. For obtaining a width of
562/560mm see picture P/1 e P/2.
INSTALLATION WITHOUT
SUPPORT
• Put the suitable plates (P/1,P/2)
on the both sides of the
embedding seat, fixing them with
the double-sticker strips (Q/1).
Pay attention to the position of
the bevel which indicates the right
position of the plates.
• Release the telescopic runners
and extract the fore part (Q/2)
• Fix the telescopic runners’
bearings with the screws as
shown in picture Q/3
• Fix the 2 L-flasks as shown in
picture Q/4
• Install the cabinet block bar using
the rectangular washers and the
specific screws M4 as shown in
picture Q/5
• Install the telescopic runners on
the both sides of the machine as
shown in picture Q/6
• Insert the machine: the telescopic
runners should be coupled with
the runners ‘ bearings which are
already fastened in the seat.
(Q/7)
• Make runners run until the safety
lock should click.
• Adjust the cabinet block bar if
necessary, for the right fastening
of the machine and screw tight
the screws as shown in picture
Q/8
• Push the cabinet block button so
that the machine will be well
fastened (F/2).
INSTALLATION WITH SUPPORT
• Put the suitable plates (P/1,P/2)
on the both sides of the
embedding seat, fixing them with
the double-sticker strips (R/1)
Pay attention to the position of
the bevel which indicates the right
position of the plates.
• Release the telescopic runners
and extract the fore part (R/2)
• Fix the telescopic runners’
bearings with the screws as
shown in picture (R/3)
• Put the little flask in the right
position and fix it with two self-
threading screws on the base of
the embedding seat as shown in
picture R/4,R/5.
• Install the telescopic runners on
the both sides of the machine as
shown in picture R/6
• Insert the machine: the telescopic
runners should be coupled with
the runners ‘ bearings which are
already fastened in the seat.
(R/7).