User manual

− The steam nozzle should be periodically cleaned. Preparing milk for cappuccinos

could dirty the inside of this nozzle. Therefore remove it as it is shown in the

figures above and wash with a sponge in warm water.

Attention:

Before cleaning the steam nozzle, always switch the

machine off and wait for at least 20 minutes so that the steam pipe

can cool down. This will avoid the risk of scalding.

WATER RESERVOIR

− If the machine is not used for long periods, change the water in the reservoir

and drain the boiler by pressing the coffee button several times.

− Clean the water reservoir periodically to scrape off any scale of limestone.

− The water reservoir can be washed in a dishwasher.

− When using the decalcifying Brita filter, replace it after approximately 2000 cups

of coffee or at least every six months.

CLEANING CYCLE OF THE BOILER

− This espresso machine is an appliance using water, therefore it is normal that

some scale of limestone can form in its boiler.

− Then it is better to carry out the following operations every six months:

− Fill up the water reservoir with 1.5 litres of water adding half a glass of vinegar

or citric acid.

− Carry out the same operations as preparing some cups of coffee (refer to the

previous Chapter “Coffee”), but without ground coffee nor pods, so that only

water will flow out of the filter holder until the reservoir is completely empty.

− Fill the reservoir again with cold water and repeat the above process (without

using coffee as before) to rinse the boiler.

15. INSTALLATION

HOUSING INTO MODULAR FURNITURE

Installing the machine into modular furniture with proper characteristics will ensure a

correct operation of the equipment.

Complying with the safety rules, ensure a proper protection against any contact with

the electric components and with the parts protected only by functional insulation,

by housing the machine correctly into the furniture.

All components that guarantee protection, even a cover panel (for instance, when

the machine is positioned at one of the ends of the modular furniture), should be

firmly fixed so that they cannot be removed without tools.

Install this machine at a certain distance from refrigerators or freezers, because the

heat it sends out can impair their functioning.