User manual

7
Hardness of water:
− Before filling up the water reservoir,
make sure that the decalcifying Brita filter
has been soaked in cold water for at least
30 min. (however follow the instructions
printed on the filter package). After this
operation insert the filter into its proper
seat inside the reservoir as it is shown in
the figure.
− If the machine will not be used for long
periods, change the water in the
reservoir and drain the boiler: the
machine has to dispense about half a litre
of water (refer to the chapter”Hot
water”).
− Brita filters are available at any retailer of
electrical household appliances, at our After-
Sales Service Centres or at the Shops of
Authorized Spare Parts.
− Extract the reservoir as it is shown in the
figure; then fill it with spring water
(approximately 2.5 litres).
− Insert the reservoir again in its own
housing caring to match the two clutches
of the bottom.