User's Manual

52
software version this cannot be changed.
If not already entered by your AEG PS service team: Enter your service contact
Screen 3.2:
In this screen you can program the baud rate of communication (port 0 and port
2). The options are the following
• “1200“
• “2400“
• “4800“
• “9600“
• “19200“
You can program the parity communication (port 0 and port 2). The options are
the following:
• “NONE“
• “ODD“
• “EVEN“
You can program the number of stop bits communication (port 0 and port 2).
The options are the following:
• “1“
• “2“
You can program the protocol communication (port 0 and port 2). The options are
the following:
• “SEC“
• “MODBUS“