Operating instructions

Miniature circuit breaker

triggered

Press reset button of miniature

circuit breaker;

Mains normal, but

“Battery” LED flashes

Mains cable loose Insert the plug firmly into the

non-

heating appliance socket of

the UPS.

Software is not installed

correctly

Check the software settings.

Support is available at

www.AEGpartnerNet.de

Communication

between UPS and

computer interrupted

Cable not connected properly

Check that the RS232/USB

cable is firmly connected to the

COM or USB port of the

computer and confirm the

settings again

If you cannot solve the problem that has occurred, stop the

entire procedure, switch off the UPS and disconnect the

connector from the socket. Please contact our hotline in this

case (see page 5).

Please have the serial number of the unit as well as the

purchase date at hand. The hotline will provide you with

technical support and can inform you about further procedures

once you have described the problem.