Operation Manual

Protect PV.250 Operating Instructions
Page 32 of 51 80000027023 BAL, en
Fig. 16 Main menu
If the configuration does not start, you must wait for 10 seconds
and repeat the procedure. Make sure that no data is received via
the X2/X5 interfaces during this time.
Press one of the following keys in the main menu:
• <CR> to save all settings, finish the configuration and acti-
vate the MultiCom interface.
• <ESC> to cancel the configuration.
• <2> to access the X5 data transmission configuration.
• <4> to access the X5 data protocol configuration.
The possible keyboard actions are shown in the menu in "< >".
The following special keys can be used in all menus:
<CR>: Carriage Return (↵) or ENTER key
<ESC>: Escape key
<TAB>: Tabulator (→) key
<BS>: Backspace (←) or rubout key
< >: Space bar