Operation Manual

Protect PV.250 Operating Instructions
Page 33 of 51 80000027023 BAL, en
6.1.4.2 Configuring the Modbus Protocol
To access the X5 data protocol configuration, you must press
<4> in the main menu:
Fig. 17 Data protocol configuration
Press one of the following keys in the "X5 Data Protocol" menu:
• <TAB> to configure the Modbus protocol.
• <CR> to save all settings. The configuration is finished and
the main menu is opened again.
• <ESC> to cancel the configuration. This opens the main
menu.
Fig. 18 Modbus protocol configuration
Press one of the following keys in the "X5 Data Protocol – Mod-
bus/JBusV2" menu:
• <!> to load the factory settings.
• <1> to configure the Modbus slave address.
• <2> to configure the delay time between a request from the
master and the response from the slave.
• <CR> to save the settings. The configuration is finished and
the main menu is opened again.
• <ESC> to cancel the configuration. This opens the main
menu.