Installation Instructions

Removal is performed in the reverse order of mounting. With a firm grip at the lower end of the

inverter, lift the inverter approximately 20 mm vertically. Pull the inverter slightly away from the

wall. Push upwards at an angle until the wall plate releases the inverter. Lift the inverter away

from the wall plate.

3.4. Opening and Closing the Inverter

Remember to observe all ESD safety regulations. Any electrostatic charge must be

discharged by touching the grounded housing before handling any electronic com-

ponent.

Illustration 3.7: Loosen Front Screws

Use a TX 30 screwdriver to loosen the two

front screws. Turn the screwdriver until the

screws pop up. They are secured with a

spring and cannot fall out.

3. Installation

12 8000038781_00_BAL_en / L00410564-01_02