Operation Manual
English
27
• If the radiator should fall over, rst remove the plug
from the socket and allow the radiator to cool down
before returning it to an upright position.
Assembling the Rollers
CAUTION:
Before the device is used for the rst time the rollers
have to be attached.
Please also see our illustration!
• Turn the radiator upside down.
NOTE:
It is best to place a blanket underneath so that the
housing is not damaged.
•
Place the U-shaped brackets between the rst and se-
cond and between the last and penultimate n (Pos 1.).
• Insert the ends of the brackets through the holes in
the roller carriers (Pos 2.).
• Attach the brackets with the wing nuts.
Instructions
Unpacking
• Remove any protective foils and transport packaging
from the device that may be present.
• Unwind the cable completely.
Electrical connection
• Make sure that the iron voltage (see name plate) and
the line voltage match.
• Turn the switch to 0 or MIN..
• The mains plug should only be inserted into a cor-
rectly installed 230 V ~ 50 Hz socket with earthing
contact.
Connected Wattage
The three power levels of the devices are as follows:
RA 5520 = 1500 W
RA 5521 = 2000 W
RA 5522 = 2200 W
With this connected load a separate supply line pro-
tected by a 16 A household circuit breaker is recommen-
ded.
CAUTION: OVERLOAD
• If you use extension leads, these should have a
cable cross-section of at least 1.5 mm
2
.
• Do not use any multiple sockets, as this device is
too powerful.
Safety Switch
Your radiator has a safety switch which turns o the elec-
tricity as soon as the device falls over. The safety switch
prevents dangerous situations caused by overheating.
CAUTION:
Always place the device in an upright position in order
that it is stable and in order to prevent malfunctions..
NOTE:
The device switches on again automatically as soon as
it is placed in an upright position.
Levels/Heating Power
Adjust the heating level by means of the selector switch.
Switch turned to level:
I = low power
II = medium power
III = high power
0 = the device is o
NOTE:
Select low power, for example, for a small room. If this
is not enough, turn the radiator to the medium or high
level.
Levels/Heating Power
By regularly switching the radiator on and o , the
thermostat ensures that the desired temperature is
maintained.
In order to nd the ideal thermostat setting, please
proceed as follows:
• Turn the thermostat control to „MAX“.
• As soon as the desired temperature has been reached,
turn the thermostat control slowly down until the
radiator turns itself o . The control lamp on the
switch goes o .
• The radiator will now automatically stay at the
desired temperature.
CAUTION:
When the device is no longer being used you should
always remove the mains plug.
Turning O
If you would like to turn the radiator o , move the
switch to MIN or 0 and then remove the plug from the
socket. The control lamp goes o .
Cleaning and Cable Storage
WARNING:
Always remove the power cable from the socket and
allow the radiator to cool down before cleaning it.
CAUTION:
Do not use any type of detergent, abrasive or polish
on the housing of the radiator as this may damage the
surface.
05-RA 5520.indd 2705-RA 5520.indd 27 24.07.2008 14:20:30 Uhr24.07.2008 14:20:30 Uhr