Operation Manual

For the Fitter

• Wire the room temperature regulator according to the circuit diagram

(see circuit diagram, page 6)

- Short black wire of switch 2 (S2) to room temperature regulator 5 (N6)

- Long black wire of switch 2 (S2) to (L) terminal strip X1

- Black wire (long) from heating resistor 6 (E9) to room temperature regulator 5 (N6)

- Blue wire from heating resistor 6 (E9) to (N) terminal strip X2

- Black wire from regulator 5 (N6) to X2 LE (from above)

• Screw the radio interference suppressor (7) to the top part of the angle plate

(above terminal strip X2) with the screw provided

• Wiring of the radio interference suppressor:

- Blue wire to X1 L top (double assignment)

- Black wire to X2 L top (double assignment)

- Fix the cables in the existing cable strap in the switching area behind the angle plate.

All switching wires must be fixed in the switching area in such a way that they neither come

into contact with the right side wall nor can be touched through the ventilation slots. They

must not be near to the cable opening either.

• Stick the valid circuit diagram over the circuit diagram on the right side wall, mark installation

and stick the control panel label to the outside of the right side wall.

• Mount the right side wall. Fix the fastening screw with toothed washer

(protective earth connection!)

M4 x 8